OEM Frigidaire Dehumidifier Parts & Accessories

Water Bucket

$142.29

Fix Number: FIX3653697
Manufacturer Part Number: 5304487153

This water bucket is for dehumidifiers. Water bucket collects condensate water that drips from the evaporator. Follow the instructions in your owner's manual to install the water bucket.

FILTER

$40.40

Fix Number: FIX16221647
Manufacturer Part Number: 5304525613

Cleaner airflow begins with a filter that can trap dust without blocking air through the dehumidifier. Heavy buildup may reduce efficiency, create odors, and place extra strain on the fan. Inspect the filter regularly and replace it if it is damaged or cannot be cleaned as directed. Match the new filter to the full appliance model because size and mounting tabs may vary. Turn off and unplug the unit before removal, then make sure the replacement slides fully into place without bending.

BUCKET ASSEMBLY

$155.15

Fix Number: FIX12746638
Manufacturer Part Number: 5304523399

Reliable moisture collection depends on a bucket that fits correctly and does not leak. Cracks, warping, a broken handle, or a damaged float may cause spills or prevent the dehumidifier from running. Clean the bucket compartment and test the float for free movement before ordering a replacement. Match the assembly to the full model number because shape and sensor contact points may vary. Unplug the appliance before removal, transfer any reusable pieces if required, and check for leaks after the new bucket is installed.

Float Switch

$31.85

Fix Number: FIX12365073
Manufacturer Part Number: 5304512488

FLOAT

$23.05

Fix Number: FIX12746631
Manufacturer Part Number: 5304523391

CASTER

$31.70

Fix Number: FIX12365071
Manufacturer Part Number: 5304512486

Compressor Start Relay

$43.95

Fix Number: FIX426380
Manufacturer Part Number: 216594300

Fixes these symptoms

Too warm
Will Not Start
Won’t start
See more...

Installation Instructions

Scott from Watkins Glen, NY

Freezer stopped cooling

On the compressor are two components. The first is the start relay which allows voltage to pass through to the compressor when it's called to run by the thermostat. The second is the thermal override which protects the compressor by shutting it down when over heated. Both are plugged into the three compressor power prongs. Thermal is plugged into the top prong, starter relay to the two lower prongs. To start the repair, pull the two wire leads off of the components. Take a pair of needle nose pliers and gently pull out the starter relay. Next pull out the thermal override. Make sure the compressor windings aren't bad by testing the leads with an ohm meter. There are how to's on the web but basically place the ohm meter in its lowest setting and take a reading between the two bottom prongs. Write this number down. It should have a resistance of about 10.5 ohms. Next, take a reading between the top and bottom left prongs and then do the same on the right side. Add the left and right reading together and they should equal the initial reading that you took across the bottom prongs (10.5ohms) or so. If not, your compressor is the issue. If all tests out OK, replace the start relay in the reverse order of disassembly. The switchout takes all of 15 minutes to perform. Made my freezer like new. Read more...