OEM Broan Parts & Accessories

Srv Filter Foam F Eurohood

$41.78

Fix Number: FIX10281103
Manufacturer Part Number: s99010175

This is an authentic replacement part designed for Broan range hoods. It is a high quality item that is sourced directly from original equipment manufacturer. Its purpose is to filter out dust and debris from the air. One foam filter is included per order. To replace this filter no special tools would be needed. Simply remove the cover and replace the filter.

Srv Thermal Cutoff For Bulb He

$10.93

★★★★★

2 Reviews

Fix Number: FIX10280017
Manufacturer Part Number: S79270237

This is an authentic OEM replacement part. This thermostat is commonly used in heat lamps. The thermostat measures temperature and controls when the bulbs are turning on and off. When the temperature goes below a certain level the heater will kick-in and when it reaches a certain level it will shut off. This thermostat helps regulate the temperate, and it helps ensure the heater is not producing unsafe levels of heat. The thermostat is sold individually.

Filter

$41.78

Fix Number: FIX10280177
Manufacturer Part Number: S97007696

This is a genuine OEM sourced replacement part designed for use with Broan/Nutone range hoods. Its purpose is to filter out dust and debris. This filter is made out of metal with fabric filter material. It is sold individually. No tools needed to replace this filter, simply take out the old filter and replace it with a new one

Light Lens

$14.06

★★★★★

1 Review

Fix Number: FIX10281344
Manufacturer Part Number: S99110437

This is an OEM light lens for a range hood and it is sold as an individual part. It is also sometimes referred to as a bulb cover, as this small plastic piece encases the bulb, protects and hides it. This part is easily installed by just snapping it into place, no tools required.

Installation Instructions

John C from BELLA VISTA, AR

The hood light stopped working (switch failure - not the light bulb or socket), the fan switch worked fine, but replaced anyway.

1. Shut off applicable circuit breaker to isolate power to exhaust hood.
2. Unscrewed the single machine screw holding the wiring channel cover in place. Used 1/8" nutdriver.
3. Tape labeled (R & L) the associated electrical wires to light switch and colored wires to fan switch for exact replacement.
4. Pulled off the connector wires by the metal clips using needle nose pliers (some were very stubborn (grease corrosion or tight).
5. Could not pinch the plastic expanders on switches and push through from rear as I expected. Had to pry switches from front with screwdriver, wiggle one side free, and then force switch through from back side. This was the hardest task as they fight to stay in place. They come out the front side only.
6. Inserted from the front both fan and light switches, noting the switch label positions of the new and old to get the wiring and on-off positions to be the same as the old.
7. Reconnected all the labeled wires to the new switch pole connectors.
8. Turned on circuit breaker and tested new switches.
9 . Replaced the wiring channel cover and screwed in the metal holding screw with nutdriver. Read more...

Srv Kit,qt 110 Cfm Fan Only

$174.89

Fix Number: FIX16529643
Manufacturer Part Number: S97020971

This is an authentic replacement part manufactured for use with ventilation fans. The blower assembly is a complete replacement part and includes the motor, blower wheel, and housing. This blower assembly is sold as an individual replacement part.

Fan Motor Hood Exhaust

$44.02

Fix Number: FIX10280453
Manufacturer Part Number: S97012248

Heating Element

$34.27

Fix Number: FIX12098594
Manufacturer Part Number: S97020888

This is an OEM heating element for use with ventilation fans and ceiling heaters. Some units allow you to turn the heating function on or off. They are most commonly found in bathrooms to help heat the room. For this repair, you will start by removing the fan cover, disconnect the wire, and remove the nuts. You will then be able to pull the heating element fan housing out, remove the screws, and remove the heating element. The installation of the new part is conducted in the reverse order.

Installation Instructions

Loretta from BRIGHTON, CO

Heater element went out

Took off light cover took out heater blower and heat element. Replaced heat element and put all back together Read more...

Srv Baffle/ring W/springs 744,

$41.78

Fix Number: FIX16529829
Manufacturer Part Number: S99528893

This part is sold individually and includes two springs. The round trim ring fits onto the bracket and helps to protect the lamp. A nutdriver may be needed when replacing this part. It is an OEM sourced directly from the manufacturer for use in ventilation fans and exhaust fans made by Broan and Nutone.

Srv Grille Slide Assy,black

$28.12

Fix Number: FIX12009610
Manufacturer Part Number: SB080814099

This is a genuine item that is supplied by the original equipment manufacturer for use with Broan range hoods. It is one of the special fasteners for the grille assembly, please make sure to refer to the appropriate diagram of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable black plastic and is sold individually.

Srv Light Lens

$14.06

Fix Number: FIX10281910
Manufacturer Part Number: SB03293051

This lens is sold individually and sourced right from the original manufacturer. This clear plastic part measures approximately 3.5-inches long by 2.5-inches wide. It helps to protect the light bulb and disperse and soften the light. If this plastic part cracks it will need to be replaced. To install your new lens, no tools are needed, just remove the old lens and pop the new one into place into the brackets.

Broan Parts

Popular Broan Parts

Installation Instructions

Installation Instructions

Broan Appliance Types

Popular Broan Models

Broan Parts

Start With Your Model Number

Popular Broan Parts

Installation Instructions

Installation Instructions

Broan Appliance Types

Popular Broan Models