Shop OEM Wall Oven Thermostats

Temperature Sensor

$41.89

Fix Number: FIX1528542
Manufacturer Part Number: 316490000

If your oven has little to no heat, is not heating evenly, or is reaching too high a temperature, there may be a problem with your oven probe. This probe, also known as an oven temperature sensor or a range probe, is found in the cavity of the oven and is used to detect the temperature within there. The probe helps the oven to maintain the desired temperature by communicating with the motherboard in the oven. You can use a multimeter to test if the probe is faulty, and if so, the probe should be replaced. Please be sure to disconnect the power supply to your range before beginning this repair, as you will be working with electrical components. The tools required to complete this repair are a quarter-inch nut driver and a pair of needle nose pliers.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Little to no heat when baking
See more...

Watch the install video

Long Oven Sensor

$34.72

★★★★★

1 Review

Fix Number: FIX1570174
Manufacturer Part Number: 12001656

This is a factory-certified oven sensor kit with two harness adapters. Its purpose is to sense the temperature inside the oven. Replacing this part can fix an oven that is not reaching the proper temperature (too hot or not hot enough), not heating evenly, or an oven that will not start. To access this part, you will need access to the back of the range. Use a Phillips screwdriver to remove the screws on the access panel. Once the access panel is removed, you will notice a hole on the right side of the oven where the temperature sensor comes out of the oven. You will need to unplug the wire harness, and then open the oven door, locate it in the upper left corner, and remove the screws holding the temperature sensor in place. Pull the sensor out of the back of the oven, and replace it with your new part.

Fixes these symptoms