Uni Refrigerator Ice Makers

Refrigerator Ice Maker Assembly

★★★★★

★★★★★

5 Reviews

This is a genuine OEM ice maker assembly for your refrigerator. The ice maker makes eight cubes at a time, by filling the mold with water from the inlet valve, freezing the water until the cubes are formed, and then ejecting them into the storage bucket. This process will repeat until the ice bucket is full. If your device is not making ice cubes, the ice maker assembly may need to be replaced. Please ensure that you disconnect the power and water supply to your fridge before beginning this repair. This kit includes the fill cup, a four-pin wire harness adapter, and tube.

Ice Container and Auger Assembly This ice container assembly is a genuine OEM replacement part for your refrigerator. This kit includes the container that holds the ice, along with the auger and blades. Replacing this assembly is an easy repair that does not require any tools. First turn the ice maker off, then remove the old container from the freezer. Line up the connector with the auger yoke, then slide the new container into place. The ice maker can be turned back on, and you will be all set.

Dispenser Crusher Housing This part may look different or be a different color than the original, but will fit and function the same as the original part.

Ice Container/Bucket Bucket only. All other parts sold separately.

Drive Gear This icemaker drive gear is for the ejector blades

Ice Container

Refrigerator Ice Dispenser Solenoid The cube solenoid allows cube or crushed ice to be dispensed on demand. 120V 60Hz

Replacement Ice Maker This part is the replacement heat-release ice maker unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harness to three round female and one round male connectors.

ICE STRIPPER This part is attached to the mold to prevent the ice pieces from falling back into the mold.

Ice Cube Tray Sold individually.