Official Samsung Range Sensors

Long Oven Sensor

$42.18

Fix Number: FIX1570174
Manufacturer Part Number: 12001656

This is a factory-certified oven sensor kit with two harness adapters. Its purpose is to sense the temperature inside the oven. Replacing this part can fix an oven that is not reaching the proper temperature (too hot or not hot enough), not heating evenly, or an oven that will not start. To access this part, you will need access to the back of the range. Use a Phillips screwdriver to remove the screws on the access panel. Once the access panel is removed, you will notice a hole on the right side of the oven where the temperature sensor comes out of the oven. You will need to unplug the wire harness, and then open the oven door, locate it in the upper left corner, and remove the screws holding the temperature sensor in place. Pull the sensor out of the back of the oven, and replace it with your new part.

Fixes these symptoms

Door won’t open after self cleaning cycle
Element will not heat
Little to no heat when baking
See more...

Watch the install video

Range Oven Temperature Sensor

$139.95

Fix Number: FIX4240743
Manufacturer Part Number: DG32-00002B

This oven temperature sensor helps regulate heat by detecting the internal temperature during cooking. It includes a 3.9-inch probe, a 3.2-inch wire harness, and a 1.7-inch support bracket. If your oven isn’t heating properly—too hot, too cold, or not starting—the sensor may need replacing. To install, unplug the range and move it away from the wall. You’ll need a screwdriver, wrench, and drill with a Phillips bit. The sensor is usually near the heating element and may require removing the rear panel to access the wiring. Removing the oven door is optional but can make the job easier.

Fixes these symptoms

Element will not heat
Little to no heat when baking
Oven is too hot
See more...

Oven Temperature Sensor

$142.95

★★★★★

1 Review

Fix Number: FIX4240744
Manufacturer Part Number: DG32-00004C

This oven temperature sensor plays a critical role in maintaining consistent cooking performance by monitoring the internal temperature and relaying that data to the control board. By regulating the heating elements, it ensures your oven reaches and maintains the desired temperature throughout the cooking process. A faulty sensor can lead to inaccurate heating, temperature fluctuations, or error messages. Replacing this component can restore proper temperature control and improve overall oven reliability.