Official Admiral Range Hardware

Screw - 10-16 x 1

$7.30

Fix Number: FIX11741409
Manufacturer Part Number: WP3387230

This is a multi-use screw mostly used in dryers. It has a diameter of #10, length of one inch, and thread size of 16. Remember to follow safety practices and instructions provided in the manufacturer manual. *Please note: this screw is sold separately.

Range Screw

$7.30

Fix Number: FIX11750186
Manufacturer Part Number: WPW10200660

Fixes these symptoms

Door won’t close
See more...

Dryer Screw

$7.30

Fix Number: FIX11746840
Manufacturer Part Number: WP90767

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the manufacturer for further repair guidance.

Range Screw w/Washer

$7.30

Fix Number: FIX11744138
Manufacturer Part Number: WP74006515

This is a replacement screw and washer for your oven/range. It is a Phillips-head screw approximately half an inch long, and the washer is approximately 1 inch in diameter. The screw attaches the oven door handle to the door. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Watch the install video

Leveler Foot Screw (Nylon)

$23.05

Fix Number: FIX16875974
Manufacturer Part Number: W11665456

This part includes one range leveling leg, sourced directly from the original manufacturer. The leveling leg is what supports the range and ensures it is sitting level, stable, and at the proper height. If your range has suddenly become wobbly, we suggest checking the leveling legs for damage. For this simple repair, you may need a pair of slip-joint pliers. Tilt the range forward enough so that you can tilt it back and place wood blocked under the front to keep it propped up (making sure it is stable). Unscrew the old leveling leg by hand, or with your pliers if it is broken and hard to remove. Place the new leg into the opening and screw it into place, be careful not to cross-thread it. Place it at about the same distance that the original one was in. Set the range back down on the floor and continue to level it with your pliers. Once the block has been removed, make sure it is sitting flat on the floor and adjust as needed.