OEM Maytag Food Waste Disposer Parts & Accessories

Splash Guard

$32.72

Fix Number: FIX11742344
Manufacturer Part Number: WP4211334

This is a flexible rubber cover that fits over the top of the sink drain. It opens up in the middle and will allow you to feed water or food items into a garbage disposal while keeping liquids and smaller food particles from splashing back into the sink.

Fixes these symptoms

Garbage comes back up sink
Smells bad
See more...

Installation Instructions

Greg from Ridgefield, WA

There were 2 problems. KitchenAid does not have installation instructions for this model. One step in the take down/installation wwas tough.

I found that while KitchenAid did not have any info on KCD1250S1, it did have instructions for KCBD250S1 and the two are very similar. so I used those instructions - which were not as complete as one would like, but with some experimentation they gave me enough clues that it worked. First, do not remove the red cover or the Styrofoam that is underneath the plastic. Second, the removal of the disposal was easy once I learned that the key was to stick a Allen head screwdriver into one of the round metal openings that hide above the red plastic cover. Then shove the screwdriver (which will rotate the metal fitting) clockwise when you are underneath looking upward. Catch the heavy disposal when it decides to come loose. Do everything to get the new parts into place, it's easy. Put the Flange, seals and brackets in place and tighten the screws. The next step is putting the screwdriver into one of the rotating flange metal holes, then forcing the heavy disposal completely up into the flange fitting (I had to look down through the sink drain hole and guess where everything really was), and shoving the screwdriver (rotate the flange) counter clockwise, again when looking up from beneath the disposal. I suspect that if you do this a few times it gets easier. It now works perfectly. Read more...

Watch the install video

Hose Clamp

$11.10

Fix Number: FIX11740613
Manufacturer Part Number: WP285655

This hose clamp is sold individually.

Fixes these symptoms

Leaking
Will not drain
See more...

Installation Instructions

Jacob from Center, TX

The drain hose had a hole in it and needed to be replaced

Removed the lower front panel, disconnected the hose and replaced it with the new one, then replace the panel. The most dificult part was getting my old self on the floor and unscrewing the panel nuts. Read more...

Hose Clamp

$9.81

Fix Number: FIX11743289
Manufacturer Part Number: WP616099

Note: This part has been updated by the manufacturer. It may appear different but will still function the same as the original.

Fixes these symptoms

Leaking
See more...

CONNECTOR

$21.90

Fix Number: FIX971184
Manufacturer Part Number: 4396672

Splash Guard

$27.73

Fix Number: FIX357521
Manufacturer Part Number: 4211615

This is a flexible rubber cover that is over the top of the sink drain. It keeps liquids and smaller food particles from splashing back into the sink.