Amana Dishwasher Dishracks

Rack Track Stop

★★★★★

★★★★★

1 Review

This is a single rack track stop clip used to prevent the upper dish rack from sliding all the way out of the dishwasher. It is made of gray plastic and can wear with time. This is an easy repair that should not take very long to complete. Start by opening the dishwasher door, depress the tabs to remove both the front stop clips and remove the upper dish rack from the appliance. Now, using your small flat head screwdriver, release the retaining tab to remove the rear stop track that you are replacing, and pull the clip up to remove it. Install the new clip by inserting it into the support rail from the top and press it down to secure it in place.

Front Track Stop

★★★★★

★★★★★

1 Review

The Front Track Stop is used to keep the top rack of your dishwasher on the rails (also called a track), by preventing the rack from being pulled out too far. The stopper is attached to the front end of the rail and is used on both sides (left and right rail) of the appliance. If you need track stops for the back ends of the rail, they are sold separately. This is a genuine OEM part and is sold individually. If both the left and right side of your dishwasher top tracks require new stops, please ensure you add the correct quantity to your cart. This part is made of plastic and is easy to install in your dishwasher. No tools are needed for this repair, simply pop off the old stopper and snap the new one into place.

Rail Stop Clip The Rail Stop Clip is found at the front of your dishwasher top rack rails (also called a track), and they are used to stop the top rack from falling off the rails. If these clips are damaged or missing, they should be replaced. By capping off the end of the rails, it prevents the top rack from being pulled out all the way. The clip is made of plastic and is a genuine OEM part. Installation is simple and no tools should be needed to complete this repair. Once the old clip has been removed, the new part snaps into place. The part is sold individually and works for both the right and left side tracks. If you need to replace the Rail Stop Clip on both tracks (left and right side) please ensure you buy the correct quantity as they are not sold in pairs.

Dishrack Guide Rail Stop - gray This dishrack guide rail stop is made of plastic and is gray in color. It is an inch and a half long.

Dishwasher Cutlery Basket Silverware Basket

Upper Dishrack Track This track attaches to the inside of the tub for the upper rack to glide in and out.

Silverware Basket This is a basket for washing flatware or silverware in your dishwasher.

Lower Dishrack with Wheels NOTE: Per factory, this substituted part only has 6 wheels instead of 8 and NO longer comes with shelf rack.

Silverware Basket

★★★★★

★★★★★

1 Review

This silverware basket sits in the lower dishrack and holds small utensils like forks, knives, and spoons during the dishwashing cycle. The basket is made of high quality grey plastic and measures approximately 19 inches (length) x 8 inches (height) x 4 inches (deep).

Lower Dishrack Kit This kit includes the dishrack, clips, wheels and silverware basket. As per the manufacturer this kit no longer includes the tines.