Admiral Dishwasher Parts

Admiral Appliance Parts

Popular Admiral Dishwasher Parts

★★★★★
★★★★★
10 Reviews
Fix Number
FIX10065979
Manufacturer Part Number
W10712395
This OEM dishwasher upper rack adjuster kit includes the left and ride side adjusters and all the parts needed to repair the upper rack. These parts have changed from plastic to metal, so even though it looks different than the original part, it is made to be perfectly compatible. This part is located on the dishwasher rack and is connected to the track, allowing it to move in and out smoothly. If this part is damaged, it may make it difficult to move the rack in and out or it might hang down awkwardly, indicating a repair is needed.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Leaking
  • See more...

Installation Instructions

gregory from cooperstown, NY
New parts are not identical to original
I was expecting original equipment parts, so initially opening the box I was surprised and thought that I would be sending them back. The new parts were, however, correct, and actually of better quality than the original. More steel and less plastic. Dimensions were the same but connections were very different. Instructions were included with photos instead of diagrams. I do prefer well drawn "exploded" diagrams, based on years of experience putting tools and machinery together. The first rack adjuster took 10 minutes and a little head scratching, but the second one took about two minutes. Add about three minutes to remove the old adjusters and the entire job took 15 minutes. I would advise the manufacturer to provide a detailed diagram instead of photos. Read more...
Rack Track Stop
$7.70
In Stock
★★★★★
★★★★★
2 Reviews
Fix Number
FIX11746591
Manufacturer Part Number
WP8565925
This is a single rack track stop clip used to prevent the upper dish rack from sliding all the way out of the dishwasher. It is made of gray plastic and can wear with time. This is an easy repair that should not take very long to complete. Start by opening the dishwasher door, depress the tabs to remove both the front stop clips and remove the upper dish rack from the appliance. Now, using your small flat head screwdriver, release the retaining tab to remove the rear stop track that you are replacing, and pull the clip up to remove it. Install the new clip by inserting it into the support rail from the top and press it down to secure it in place.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Noisy
  • See more...

Installation Instructions

Richard from Austin, TX
Wheels on original upper rack adjust fell off and end stops would not stay on.
Removed old end stops. Pulled rack out of machine. Carefully removed old adjusters. Snapped in new adjusters. Slid rack back into the runners. Clipped in the new end stops. Done. Read more...
★★★★★
★★★★★
2 Reviews
Fix Number
FIX8260087
Manufacturer Part Number
W10518394
This is a manufacturer-approved heating element and 2 washers. If the dishes in your dishwasher are not drying or the water in the dishwasher is not getting hot, it may be due to a failed heating element. The heating element is not intended to heat the water that enters the appliance but is designed to maintain the heat of the water that enters. This part is located on the bottom of the appliance. Be sure to disconnect the power to the appliance before you begin this repair. Start this repair by disconnecting the wires from the bottom of the element in the back, remove the plastic nuts holding it in place, remove the element, and repeat these steps in reverse order to install the new part. For this beginner repair, you will need a screwdriver, wrench set, and it should be completed in less than 30 minutes.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not draining
  • See more...

Installation Instructions

Jesse from Mandan, ND
not drying or cleaning dishes
Turned off breaker at power source. Turned off water supply valve. Disconnected water supply hose and drain hose. Removed base panel with 1/4'' nut driver. Removed power box cover screw with 1/4'' nut driver, turned off wire nuts connecting power cable and used phillips screw driver to remove ground. Removed 2 phillips screw under front of counter holding dishwasher in place. rolled dishwasher out of cabinet and layed face down on towels. Pulled two wires connected to the element marking position prior. Then removed two heater element nuts with adjustable wrench. Tipped dishwasher up, opened door and lifted out lower rack, underlower rack is heating element and lifted out. Reverse procedure to install. Read more...
Mounting Bracket
$10.03
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX11745496
Manufacturer Part Number
WP8269145
The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to side mount your appliance, and this type of bracket is sold separately. It is important to properly secure your dishwasher, as it helps to keep it level, and prevents it from moving, shaking, or tilting forwards. This is an authentic OEM part, made entirely of metal, and approximately 3 inches in length. These mounting brackets are sold individually, however most dishwashers require at least two brackets to secure the appliance to the countertop. It is recommended to check and replace all brackets at the same time, as they tend to wear at the same rate. Attaching the mounting bracket to the top of the dishwasher is simple, and just requires a pair of needle nose pliers to bend the tabs into place. When it comes time to attach your dishwasher to the countertop, please note that you will need screws (sold separately), a screwdriver, and if this is the first time the brackets are being attached, you will also need to use a drill bit to make pilot holes for the screws.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Leaking
  • See more...

Installation Instructions

julie from arroyo grande, CA
Mounting bracket broken. Upper rack wheel broken.
Upper Rack Wheel Assembly - This is a little time consuming (maybe 15 minutes), but easy. You will need to remove the entire upper rack assembly before replacing the wheels. After you remove rack assembly and the dishwasher from under the cabinet (see guidance below for brackets), you will see two hex head sheet metal screws with integral washers on the outside of the dishwasher holding the wheel assembly onto the dishwasher. Use the pliers to remove the screws and the old wheel assembly. Install the new wheel and mount assembly using the old screws since the wheel assembly doesn't come with the mounting screws. Mounting Bracket - Pretty easy. Remove port cover for both left & right mounting screws on inside of dishwasher. Remove the screws (if they haven't already fallen out). Careful - they will drop to the floor. Pull the dishwasher partially out from under the counter. Remove the old bracket(s) and install the new one(s). You will need pliers to bend the tabs over to secure them. For the Kenmore, you need to break off the longer end. Slide the dishwasher back under the counter and align the screw holes with the cabinet. I use masking tape to hold the screw on the screwdriver so it doesn't fall off when inserting into the screw hole in the cabinet. Use the flashlight to help see that the holes are aligned. Tighten the screw and you're done. Read more...
Fix Number
FIX11750093
Manufacturer Part Number
WPW10195840
The dishwasher positioner clip is also known as a rack adjuster and is used to hold the top rack in your dishwasher in the desired position. If the rack is not staying in place, the clip may have become damaged and should be replaced so that your dishwasher can clean as efficiently as possible. No tools are required for this repair, but you may find a flat blade screwdriver useful for prying off stubborn parts. To replace this part, you will need to take the top rack completely out of the dishwasher, and this will require removing the track stop clips from the ends of the rail. Once the rack is on a suitable work surface, remove the broken clip by releasing the locking tab and install the new one ensuring it clicks into place. The upper rack can now be placed back into the dishwasher, and the track stop clips can be reattached.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Not cleaning dishes properly
  • See more...

Installation Instructions

Martin from Sheridan, OR
The upper rack wheels made of plastic broke and rack fell.
ordered parts from detailed drawings on parts.com for my model. I was a little confused at first due to the fact that new parts were metal(better) , instead of plastic like old parts. But after looking at the instructions that came with the new parts, it made sense. Went fast after that. Read more...
Friction Sleeve
$7.49
In Stock
★★★★★
★★★★★
3 Reviews
Fix Number
FIX11745488
Manufacturer Part Number
WP8268961
The friction sleeve, sometimes called a friction pad, is made of a flexible black plastic and measures a bit over one inch in length. It is designed to reduce the friction between the hinge and the door on your dishwasher, and helps keep it quiet when the door opens and closes. If the door to your dishwasher drops quickly when unlatched, you may need a new friction sleeve. The sleeve is sold individually however there is one located on both the left and right side of the dishwasher. We recommend replacing them at the same time so that they wear evenly. Replacing this genuine OEM part is an easy repair, but it will require you to pull the dishwasher out from under the counter.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Noisy
  • See more...

Installation Instructions

kathleen from Kenner, LA
after unlatching dishwasher door fell open-- no resistence
Pull out dishwasher, removed old sleeves (was split), released spring mechanism, slipped on new sleeves, re attached spring mechanism, reset dishwasher. Read more...
GASKET
$20.89
In Stock
Fix Number
FIX16221222
Manufacturer Part Number
W11498831
Fixes these symptoms
Lower Spray Arm
$60.74
In Stock
Fix Number
FIX11755592
Manufacturer Part Number
WPW10491331
This is a lower spray arm for a dishwasher. The lower spray arm allows water to be spread evenly throughout the dishwasher tub with the proper force so dishes come out clean. This spray arm is gray in color and is about 20 inches long. You may need to replace this part if the water is not being distributed.
Fixes these symptoms
  • Leaking
  • Noisy
  • Not cleaning dishes properly
  • See more...
Middle Spray Arm
$30.89
In Stock
Fix Number
FIX11755664
Manufacturer Part Number
WPW10498900
This is a replacement middle spray arm in your dishwasher. You will find your middle spray arm mounted on the bottom of the middle dish rack. The upper spray arm rotates and sprays water during the operating cycle. If your dishes are not coming out of the dishwasher clean, you may have a malfunctioning middle spray arm. Debris and hard water buildup in your dishwasher can cause the middle spray arm to clog. To replace the spray arm, simply turn the arm counter clockwise to release it from the dish rack. Screw in the new spray arm to complete the repair. This part is sold individually.
Fixes these symptoms
Dishwasher Filter
$31.89
In Stock
Fix Number
FIX11759673
Manufacturer Part Number
W10872845
This genuine OEM filter is found under the lower spray arm in the bottom of your dishwasher. It is used to trap debris and prevent it from entering the pump. If your dishes are not properly cleaned or your dishwasher has trouble draining, there may be an issue with your filter. Regularly cleaning the filter can help prevent these issues but over time the filter can become clogged or damaged and will need to be replaced. The filter is cylindrical in shape, with a gray plastic top and bottom and measures approximately 6 inches in length and 4 inches in diameter. No tools should be required to replace the filter. Simply twist the old filter counterclockwise to remove it and insert the new filter twisting clockwise to lock it in place.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not draining
  • See more...

Admiral Dishwasher Appliance Types

Related Admiral Dishwasher Parts

Popular Admiral Dishwasher Models