JFFCF72DKM01 Whirlpool Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Margaret from Minneapolis, MN
- Parts Used:
- WPW10534155
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Original refrigerator kick plate snap on connector broke and no longer able to keep kck plate in place
Pushed it on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bruce from Duluth, GA
- Parts Used:
- W11291138
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
While closing the door, I somehow cracked off the light switch button.
Popped out the old one......plugged in the new one and popped it back into place. My wife was happy in have light again in the fridge!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Peter from Avila Beach, CA
- Parts Used:
- W11291138
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
broken spring in the light switch in refer
Initially thought I could repair switch, but then discovered spring was broken. Ordered the new switch (Parts Select is very efficient - received switch in 3 days). Was encouraged by the posts regarding the switch installation. I had some difficulty removing the old switch. Used a pocket knife to ease the switch out of the hole to reveal the clip/spring. After noting the clip/spring location I used a small flat-blade screwdriver to release the clip. Even though I released the "molded" clip/spring(be sure to note where the spring is on the new switch and release it on the switch it was tight in the hole and had to use pliers to carefully remove the old switch. After removing the old switch, used pliers to gently remove the wire leads. Then install the leads on the new switch. Note the orientation for replacing the switch and gently feed the connecting wires into the hole so they won't kink or prevent the switch from entering the hole. Install the switch noting the clip/spring location and the orientation of the lever that the door closes on to turn off the light. Be sure to put it in without binding at an angle. Thanks to Parts Select for this service! I'll definitely be back.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Fairfax, VA
- Parts Used:
- W11396033
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Left door light switch lost its spring
Unplugged appliance. Using a small putty knife I moved the switch out far enough to grab it with pliers. Moved wiring to new switch and pushed into place after testing.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from Bath, ME
- Parts Used:
- W11396033
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Light in Freezer Compartment Out
Changed bulb, not the problem, had to remove switch to identify correct choice to order (3 pronged verus 2) after that it was easy beyond having to stand on my head to make the exchange. (N B before removing old switch it actually came back to life)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Fred from Warwick, RI
- Parts Used:
- W11396033
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
My refrigerator light did not work.
After years of using a flash light to check the contents of my refrigerator, I decided to try to fix the problem myself. Replacing the light switch was very easy. The directions were straight forward and I'm sorry I waited so long to tackle the problem.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michalynn from Powder Springs, GA
- Parts Used:
- W11396033
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Light switch broken off by container in freezer
Pried out the old switch with small screwdriver, popped in the new one and tah-dah!! ..the light came on. While I was at it, I cleaned out the freezer :). I cannot begin to imagine what a repairman would have charged for this.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Darrell from Garrison, NY
- Parts Used:
- WPW10122078
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I had broken off the stud that fits into the "deli bin" lid and needed to replace the end cap
It was a breeze once I figured out how to remove the old part. Everything snaps together no tools required and I'm sure I saved myself a bundle by doing it myself.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph from Francesville, IN
- Parts Used:
- W11291138
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken light switch
Used the butter knife to pry the old switch out, it is a snap in switch so there is a small keeper on the bottom that needs to be pushed in to pop the switch out. Un hooked wires by pulling them off of the terminals (won't shock you) and put them on the new switch and popped it in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joanne from Bourbonnais, IL
- Parts Used:
- W11291138
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Light switch broke
Pulled out old switch with needle nose pliers, unplugged old switch and plugged in the new one and snapped back into place. Very easy to repair. Took less than 10 minutes
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lynda from Santa Rosa, CA
- Parts Used:
- WP67002332
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Glass shelf shattered during cleaning
It was greqat to find this part so easily and to be able to buy just the glass shelf without added hardware. When it arrived, I just unpacked it, washed it and put it into its place in the refrigerator. Much easier than the cleanup of the shattered glass :-)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jaycin from Snoqualmie, WA
- Parts Used:
- WPW10122078
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The brace for the deli cover had broke
Pulled out the end cap and inserted the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- dan from Westlake, OH
- Parts Used:
- WPW10122078
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
the tab that mounts the self opening lid to the pull out drawer broke off
After months of glueing and re-glueing the piece back together, I searched online using the product numbers on the back of the part. I found this website instantly and the replacement part. When I ordered the part I was concerned that it would not fit but it fit perfectly and the repair cost $20. I had a great experience with this site and will use it again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Melodie from Gouverneur, NY
- Parts Used:
- W11291138
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Light switch was broken off.
Purchased the new light switch, used a butter knife to pop the old one out, used the pliers to pull the wires off the metal tabs, replaced the new one with no problem. Took about under 1 minute. Lights are now all working.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jim from Gleason, TN
- Parts Used:
- W11395888
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
new maytag filter clogged twice in two weeks no ice or water
Took out 2nd new filter $43.00 each that clogged in less than 2 weeks each and installed in 2 mins. this bypass and ice and waterr work perfect.Thank you, thank you for your exceptional service ordered part and it came next day without extra charge,great service.
Was this instruction helpful to you?
Thank you for voting!