Models > KFXS25RYMS > Instructions

KFXS25RYMS KitchenAid Refrigerator - Instructions

Jump to:

All Instructions for the KFXS25RYMS
91 - 105 of 127
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
David from Portland, OR
Parts Used:
EDR4RXD1
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Replaced ice & Water filter, but message on refigerator still shows "Replace Filter"
As per instructions to replace filter
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard A. from Boones Mill, VA
Parts Used:
WPW10196393
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Milk was freezing in Refig section, 28 F temp
Noted the Damper Assemby in the upper rear of refrig section,was always staying open during checks for problems. Controls appeared to be controlling temp changes when adjusted. Pulled the damper assemby after removing two screws holding the diffuser/cover(diffuser pops off with screwdriver) Damper assembly snaps out , unplug wires, snap new damper assembly in place, reconnect wires at the plug, replace cover with foam insulation, secure with screws replace diffuser snaping in place. Recheck settings for desired temperatures.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Nancy from Urbandale, IA
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Repace Water filter
20 seconds. Easy Easy.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lynn from Rome, NY
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Filter needed changing
Simple! Pop the case open. Counterclockwise to remove old filter. Wipe out excess water. Unwrap new filter; remove tab. Place in filter holder; turn clockwise. Close case. Run water to remove air. Couldn't have been easier!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Patricia from Huntsville, AL
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
needed new water filter
Screwed new filter in
Was this instruction helpful to you?
Thank you for voting!
Customer:
james from kansas city, MO
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
replaced water filter
followed instructions on box
Was this instruction helpful to you?
Thank you for voting!
Customer:
gary from New York, NY
Parts Used:
WPW10498990
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Water inlet valve was leaking.
To replace the water inlet valve was very easy. All you need to do is unscrew the valve from the back of the refrigerator then use pliers to remove the water line then unplug the 2nd line that goes into the frig. Then just unplug the valve from the power cord.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Daniel from Chicago Heights, IL
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Installing the Ice and Water Filter
Take filter out of the box and open the refrigerator. Open the housing in the frig that holds the filter and twist the light-blue piece 1/4 turn, counter-clockwise. (Put the light-blue piece in a safe place.) Take foil away from filter. With 1/4 turn in the clockwise direction, twist the filter into its position. Let five gallons run through the system to get fresh, filtered water.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Myra from Baltimore, MD
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The water filter indicator kept blinking red.
I opened the cover to the filter and screwed the filter counter clock wise until it came loose then removed the old filter and put the new one in. It was real easy.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from Dallas, TX
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Water filter change
Easy unscrew remove and install new filter
Was this instruction helpful to you?
Thank you for voting!
Customer:
ROY from SOMERSET, NJ
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Filter Needed Replacement
Opened filter area door turned old filter to the left to unscrew. Took out old filter then replaced the new filter and turned it to the right to tighten it, closed cover and that was it all done.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Louis from Covington, KY
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Ice and Water Filter needed to be replaced.
I snapped the cover plate to the filter open. Pulled the filter down and twisted counter clock wise to take filter out. I installed the new filter in by inserting the filter and tuning clock wise to secure the filter. I flushed the water for about two minutes and then allowed it to be put back into service.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Alice from Ocala, FL
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Needed to install new window a/c unit
Placed in window and pulled out sliders.
Was this instruction helpful to you?
Thank you for voting!
Customer:
William from Bronxville, NY
Parts Used:
EDR4RXD1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
water was slowing down
Unscrewed the old filter and screwed in the new one
Was this instruction helpful to you?
Thank you for voting!
Customer:
Alfred from Erie, PA
Parts Used:
WPW10196393
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
noisy
Popped the cover to expose the part. Then removed two screws and unplugged the part. Exchanged the new part for the old. Plugged the new part in and replaced the screws And the cover.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the KFXS25RYMS
91 - 105 of 127