LGTR1842TE0 Frigidaire Refrigerator - Instructions

Pulled unit away from wall and shut off water and unplugged unit. Installed water valve and reassembled, plugged back in and turned on water and checked for leaks. All good. However there is no water getting into the ice maker. The unit itself is going thru a cycle of attempting to make ice and the bail is moving and you can hear the solenoid activate but no water. I have tried to blow thru the tube going to the maker but it seems to be plugged by something. I do not know if there is another valve up there or how to clean it out. Any help would be greatly appreciated.

The first order arrived in a huge box and there was no scew to be found, the box had wholes in it. I was given a refund and told to order again.



The repair did not happen and the set screw which was actually recieved the second time was returned because it was the wrong size.

Insert the bottom part of the trim first, then pull up to snap on the top. PartSelect.com is a fantastic website!!

I had no problems. Screws arrived sooner than expected. It was a very simple installation. Very pleased with both the product and service.

replaced

Two screws held the top of the handle to the door and one set screw held the bottom of the handle to the door. All I needed was a phillips screw driver and an allen wrench. It took less than 10 minutes.

I had to tap the screw holes with a 8/32 tap so that the screws would not bind.

1). Shut off water supply to fridge. 2). Move fridge out to gain access to back of fridge. 3). Remove poly line to water tube have a glass handy to catch any remaining water that might be in line. Some may have a foam insulating washer around water tube remove it first. 4). My Sears-Kenmore was a twist lock water tube have to turn it to left or right depending on brand to remove tube. 5). After removing make sure tube didn't just have water frozen in tube ( that was my problem ) run it under hot water frozen piece will come out. 5). Problem fixed, reverse directions to re-install tube!

1st a changed the defrost stat. Waist of time. Realized there was no evaporator above fan. Noticed ice was builing up behind ice maker near fill tube. Found if I shut off ice maker ice wasnt building up on fan. Moved fridge out unplugged fridge unscrewed plastic nut. Turned 90 degrees. Replaced tube locked in place . Screwed nut back on . Plugged in and turned ice maker on. Wife happy ice was back on and no noise.

Using Parts Select, followed the menus to identify the correct part. Placed order and the part was a direct swap for the old one. Removed old shelf, insert new shelf and put the drawer in. Job done!

Just a few screws and it was fixed.

Simple drop-in. No tools. Less than one minute "repair" time. Worrying that the glass would break en route was for not; huge box with lots of peanuts and bubble wrap prevented any potential breakage. Very satisfied with price, shipment (including time), and overall "repair".

Removed water line. Removed two screws holding valve. Disconnected line from valve going to Ice maker. Replaced screws and water line. Most important thing in working with Parts Select was the information they provided when I called them. I had called electrolux and was given no information and was told they would send out a repairman at which point I told them to get lost. Cost of part $30.00 vs service call of $75.00.

removed old handle using allen wrench for set screw and Phillips #2 screwdriver for top screws then reversed it to install new handle very easy

Unscrewed the screws, and loosened the set screw attaching the bottom of the old handle to a post. Attached the bottom of the handle to the post, tightened the set screw, and screwed the top of the new handle back into the door.