GLVC25V7FW2 Frigidaire Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Patricia from DENTON, TX
- Parts Used:
- 240350649
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Broke glass shelf during cleaning
Simply installed new shelf. Was very pleased how easy it was to find the correct part on the website.
It took 3 hours to clean up the broken glass and 2 minutes to install the new one!
It took 3 hours to clean up the broken glass and 2 minutes to install the new one!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gail from TIGARD, OR
- Parts Used:
- 240599803
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The frame on my meat pan cover broke.
I removed the old frame and the glass. I put the glass in the new frame and inserted the frame & glass in the shelf brackets. No tools required. Nothing difficult or tricky about the replacement and installation.
It took longer to remove the items from the shelf than to replace the new frame and glass.
It took longer to remove the items from the shelf than to replace the new frame and glass.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from FRANKLINTON, NC
- Parts Used:
- WF2CB
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
replace old filter
simple replacement
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joel W from LAUGHLIN, NV
- Parts Used:
- 240351061
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Old crisper drawer cracked
Took out old drawer. Removed clips from that drawer in rear and clipped onto new. Removed humidifier control from old and inserted into new. Slid drawer onto track.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lynn from NESCOPECK, PA
- Parts Used:
- 240351061
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Cracked crisper
Pulled out the old-put in the new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from PFLUGERVILLE, TX
- Parts Used:
- 240350649
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Crisper Glass was broken
Took the glass out of the shipping box and it just slid right in. It was a perfect match.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from PHILADELPHIA, PA
- Parts Used:
- 5303918202
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Evaporator was freezing up and was running non stop
I tested the components in the refrigerator defrost function. I used digital multimeter and checked for continuity. Defrost thermostat must 32 degrees or lower.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Frank from HOWELL, NJ
- Parts Used:
- WF2CB
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Slow water output
Followed easy instructions
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Salvador from SANTA ANA, CA
- Parts Used:
- 5303918202
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers
Freezer worked, refrigerator didn't. Ice build up on coils.
Unplugged refrigerator. Emptied freezer and removed ice maker and cover, need to unplug fan. Defrosted coils with hot water. Cut wires to thermostat as close to it ad possible to leave extra wire in case of an error. Stripped wire in new thermostat and put in shrink plastic then the wire crimp connector joining both light blue wires making sure wires were in before crimping them. Repeated with other dark blue wire. After used the heat gun to shrink the protective white tubing. The only thing i found not satisfying was tge tubing. It was too wide and too small. When i shrunk it did not cover the whole connector and was loose. I had to use a glue gun to cover both ends of each wire connector. Hope this helps other users.
Was this instruction helpful to you?
Thank you for voting!
I started hearing a loud clunking sound when I would close my refrigerator door and then eventually it stopped closing when I pushed it so I had to push it all the way closed. I searched the web site and found the parts I needed then watched a video on how to do the repair.
When my parts arrived I took a screwdriver and removed the hinge cover on the top of the refrigerator door. I then took a 3/8 drive ratchet and a 3/8 socket and removed the 2 screws on top of the fridge that hold the door hinge on( be sure to empty your door before you take the bolts out). I lifted the door out and layed it in the floor and upon inspection I found that the hinge bearing that fits inside the bottom of the door was completely broken off. I had to take a flat screwdriver and dig it out enough to grab it with a pair of pliers and pull it out. I inserted the new bearing and made sure it was all the way in then applied some petroleum jelly around it and the door closing cam. My door closing cam was still good so I didn't have to replace it. I lifted the door and placed it back in the hole on the bottom, closed the door, reinstalled the hinge on top, adjusted the door, tightened the bolts and reinstalled the hinge cover. Piece of cake thanks to the video on the web site!!! I know from now on where to go for parts I need for any of my appliances. Thanks !!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from MONTGOMERY, IL
- Parts Used:
- 5303918202
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Socket set
Coils frozen over. Refrigerator not cooling
I cut wires from bad thermostat and removed it . Stripped wires and crimped connectors on new thermostat and wires from old thermostat. Used heat gun to seal sleeves over connectors. Very helpful video from this site Thanks, you will be my go to parts supplier from now on!!!!!!!!!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nathaniel from Mastic, NY
- Parts Used:
- 5304520331, 5303918455
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Right door wasn't closing right
Emptied everthing on the RT.Remove upper guard and hinge,lift door off of lower hinge.Set it down somewhere safe.Remove lower hinge,replace with New Hinge,Door part # 5303918455, Closer Bushing part #240457702. Put the back on the frige,Boom done.."Miller Time" [or whatever You prefer} I had this problem before,and I see Frigidaire upgraded the hinge and the Plastic Bushing..Thank You
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Suzanne from TAVARES, FL
- Parts Used:
- 240599803
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
broken shelf holder
You pop the old frame out, take out the glass, slide the new frame in and reinstall the shelf. No tools required. Very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from IOWA, LA
- Parts Used:
- 240457701
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Had a popping sound when opening and closing door
Put a new door bearing and problem solved
Was this instruction helpful to you?
Thank you for voting!
Broken Crisper drawer cover and support
Removed broken parts and installed new ones. Only had a little problem getting supports out. I think they had sticky stuff from spills in the refrigerator that made it more difficult.
Was this instruction helpful to you?
Thank you for voting!