KSPZ25V9GS3 Frigidaire Refrigerator - Instructions

Pried the broken support insert out with a screw driver and pulled it out with pliers, then inserted the new and pressed it in and Presto the drawer now works good again.

It was pretty easy. The hardest part was getting the supports that had snapped off out of the walls of the refrigerator. Once that was accomplished it was a breeze.

Due to the nature of the support deisign and installation which was unusual I watched the video on how to extract the old broken support and install the new one, odering the new part was simple as the view privided in the parts section was specific and and easy choice to make, cost was very minimal and I received it the next day due to my being in close proximity to the shipping point, thank you and my crisper is very happy and so am I.

Opened the box and popped the bin in the door slot…30 seconds of repair!

Have not really done the repair yet( frig is still to full of Thanksgiving leftovers) but I am sure that with the video that was provided by this site the job will be very simple. Many thanks to the person who put the video together.
John Donnelly

Drove pins all the way thru supports & then pryed support off. Tapped new supports in place. Watch the vidio on installing new supports. I probably wouldn't have been able to get the supports off without the trick I learned to just knock them on thru. Took all of 5 minutes to replace 4 supports.

I read other comments and most suggested the fix is less than five minutes and a couple tricks (push the remaining piece into the frig if you can't pull out with pliers)and I did exactly that. Parts came in 2 days, repair took 5 minutes - it took longer to open the package. My wife thinks I'm a star!

removed the old parts with a philips screwdriver then repalced those parts with the new parts and knocked the keeper inwith the small hammer

Just as the instructions showed. opened the refrigerator, removed the water filter cover. removed the old filter and installed the new one. Very easy to do.

I pull out the broken part by push the center pin thru and then rerome all the parts. I then positioned the new part in place and push in the center pin to lock. quick and easy.

Punch out center of old support, then pull it out. Insert new suppport, insert center and tap flat with hammer. All done!

I followed the excellent directions in the video linked to the email from PartSelect. The installation was quick and easy. I rated the whole operation "a bit difficult" because, if I had seen the video before I removed the old part, I would have known that you tap the support's center rod gently INTO the wall instead of wrestling it violently OFF the wall.

The old pins have to be completely dislodged (preferably with an awl) before placing the new crisper support. The new pin of the support should be driven easily into the hole on the refrigerator´s wall with a conventional hammer (carpenter type). If you find resistance while hammering on the pin, do not continue. This probably means that the old pin is still inside the hole and does not allow the new pin to go in.

I had removed the current cover from the refrigerator by lifting it out of place. I removed the glass insert and placed it in the new crisper cover. I placed the new assembly into position, added the drawer back into the drawer slides, then the refrigerator was back to new!

I used the paint spatula to pry out the old part and then put in the new part and pushed in the holder with my fingers. Super easy.