7MMGDX655EW0 Whirlpool Dryer - Instructions

I thought I had checked the arm piece of the rack real good for a product number on my original part but I missed the number till the 2nd box came in, and a looked real careful and realized it was the same as the order I thought was bad.
Put the spring arm in first and the rack will fit in the front groove.
It would have been good if there had been a picture of the dryer arm attached to the dryer.
So I have 2 good racks and will return one if you tell me where to send it.
Keith Walden..

removed two screws from lint screen raised top removed two nut screw from front disconnected lid wire lifted front up and off removed drum cleaned all dust out replaced pulley unit with new one (with a wheel) replaced tub held it up with a bungey cord put on new belt and reassembled unit tested out back in business

I reviewed several videos on parts sites and YouTube. There is more than enough advice online showing step-by-step instructions. The only difficulty came with the rear nut holding the motor shaft to the blower fan. I used a crescent wrench with a long pipe over it for added torque. The two spring clips holding the motor in place can be removed and installed with the help of a nutdriver pushing the clip down, . The dryer was new enough so the motor needed no switch changes. The new motor is running fine.

I removed the metal piece which held the plastic "catch". There were no screws, squeeze to remove it. Then inserted the plastic part and re-inserted the metal part into the dryer door. Very simple. But even more pleasing was the easy ordering and the quick delivery of the part! Thank you so much!

Made a BIG mistake ordered replacement part based on Model number of dryer. The part I received was wrong. Took out the broken part and found a part number on it. Reordered a new part based on that number. When it arrived, replacement took about 15 minutes. Lesson learned: see if number on part to be replaced. Don't trust the Model number.

removed broken parts & snapped in new catch

New handle just snapped in - really easy. Have to compliment Part Select - I ordered handle one day and it was delivered the next day. Impressive!

I snapped the new handle into place, it took 2 seconds. The new handle was made thicker and stronger than original. Its unlikely I will be doing this repair again.

When I ordered the part over the phone was told it just snaps in. Not sure what it meant. Parts delivery was prompt. Looked at the part and it’s pisition on the dryer.And it really was very simple.

ordered a replacement handle - installed it myswelf

I opened the package with my new handle in it that I got from PartSelect, and snapped it right in place. No tools needed, took only seconds!

We didn't even look at the instructions. Just rotated the handle until it snapped back into place.

Found the belt was broken and the pulley wheel had melted, replaced the belt and the pulley, could not have been simpler. Watched the video on how to repair and in less than 15 mins was fixed. Saved a lot of money by doing it myself.

Unscrewed the inside part of the door from the outside door shell. Removed the broken pieces of the catch and replaced it with the new one. Screw the door back together. Did not need to remove the door from the dryer cabinet.

Just popped it into place. Was very easy. Took less than 5 minutes.