DPSB513EB0WW General Electric Dryer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Maureen from Canastota, NY
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
plastic door handle broke off
super simple-snapped new handle right in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Harold from Paoli, IN
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken door handle
Snapped it in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from Wilmington, NC
- Parts Used:
- WE03X37318
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
High Pitch Sqeaking durng dryer operation
Replaced drum bearing part and white slides.The problem was that it was not the drum slide support. It appears to be the the drum rear bearing of whch I am now ordering. The bearing replacement is a little more difficult, but I have taken this on as a challenge
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ryan from Wenatchee, WA
- Parts Used:
- WE11M23
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Dryer not getting hot
1) Disconnect power supply. 2) Open dryer door to find and remove two screws through dryer top. 3) Proceed to lift front dryer top panel and tap rear of dryer top with hand to left to disengage tabs and remove dryer top completely. 4) Remove two screws through front panel. 5) Gently lift dryer front panel from base tabs to partial remove panel (careful of wires which remain connected) - pivot front panel to left with wires connected. 6) lift dryer barrel with left hand / reach under barrel with right hand to release belt from tensioner pulley (very easy one-hand maneuver). pull dryer barrel belt off tensioner pulley towards you, remove belt from motor pulley below. 7) lift/pull and remove dryer barrel and belt (flex side panels). 8) take picture of wire connection locations on heating element and remove wires from tabs two locations / 3 wires. 9) remove sensors 3 locations. 10) remove heating element and housing. 11) install new heating element / housing and reverse process. .....tip; belt tensioner pulley was biggest challenge at first because it was hard to see how it all worked and reach. once i realized i could force / lift the barrel up to gain better access it was much easier than trying to fit my arm through the one large available hole at bottom right (when looking at the unit). the tensioner pulley is opposite side (left when facing) and you would have to reach over the exhaust, etc.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lucille from Flatwoods,, KY
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
door handle broke off
The repair was simple, the old one broke off and, the new one fit to a tee. Thanks Parts select.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Alpharetta, GA
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Dryer handle broke off
You guys are awesome! It took me less than 5 minutes to look your company up, place the order, and closeout. Vroom...the part was to me in 3 days! I simply took it out of the wrapper, pressed the tabs into the existing slots, and done. And that cost....baby it's good. Thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tarleton from Newport, RI
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Original handle on dryer door broke off
Aligned new handle with slots in dryer door and snapped into place. It took 5 seconds.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stu from Allentown, NJ
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
original dryer handle broke after 12 years
New handle popped on easily. After 2 weeks the replacement handle just broke.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- jeffrey from hertford, NC
- Parts Used:
- WE03X37318
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Loud Squealling noise from dryer
Opened the door and removed 2 screws from inside/top of door. Removed top and then removed 2 screws from back of front panel. Lifted drum slightly to remove front panel and attached new slides.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Fernando from Verona, NJ
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken door handle
Very easy to install, snaps right in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sarah from Rochester, NY
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken handle on dryer
The part was shipped quickly and I received it within the week. I was afraid that because it is an older dryer the new handle would not be compatible, but it was! It installed easily, it only took a few seconds to clip it in and now it's as good as new!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Pam from Thayer, MO
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Dryer door handle broke
new handle just popped right in the slots
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donald from Central Islip, NY
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I broke the handle on the dryer door.
All that was needed when I got the new handle from Fed-ex, was simply to line-up the clips with the holes in the door and push in till everything snapped in place. It was very easy. It took longer to open the package than to attach the handle.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Craig from Lee Center, NY
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken dryer door handle
Handle was the exact replacement slipped it into the handle slots and pushed in to lock in place.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dorothy from Flushing, MI
- Parts Used:
- WE01X20419
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Bottom clip on handle broke off
Removed handle from box...walked into the laundry room...snapped part into the door panel. All done! Thanks for the prompt delivery.
Was this instruction helpful to you?
Thank you for voting!