GLEQ642CAS0 Frigidaire Dryer - Instructions

Got the proper part and it worked great

replaced the knob. The key was the photos. It was celar that the part you had was the one I needed beacuse the phots were clear and with enough angles to assure me I was orederig what I needed.

I grabbed the new knob I ordered from Partselect.com with my right hand, aligned it, and put it on. Works like a charm!

I had my landscape guy, who volunteered to look at the dryer since he's also an electrician, come in and take a quick look. he turned the knob, pulled it off and told me the inside was cracked so it would not grab the turn mechanism. Who knew? I got the model number from the dryer door, checked in on the internet for Fridgedaire parts, found Partselect.com, ordered part, came next day, knob fits, dryer works. end of story. THANK U!!!

just unplugged the old one, plugged in the new made sure it worked and put it back together.

first i had a helper my 9 year old son. we came to this site and read a repair report and we used that to go by.once again my 9year old.

I used the posts on the site to ascertain the problem (fuze or element burnt out). The pictures were very helpful. I pulled the dryer to the floor and using my meter checked both the fuze and the element. The electrical diagrams were very helpful also. I took the dryer apart further to make sure the coil was indeed the problem. I then ordered the part!

Removed obvious screws to the vent etc. Then had a little trouble getting the cabinet open. My only problem was getting the front top panel off. A clip about 2" from either side at the top needs to be pushed in with a flat head screwdriver to release the top. Other than that the task was pretty straight forward. Two sets of wires to the heater itself. Used pliers to help pull them loose.

Removed the top of the dryer above the dryer door by pulling the pop out plastic holds. I then removed the dryer plug in at the top inside dryer that controls the start when dryer door is closed. I thenremoved the screws that are located at the back of the dryer tub where the bearing is located. I then replaced the support bearing. I just replaced every thing I took off in reverse.

Purchased new knob and put in place this company was great received with a day or two

I replaced this belt once before but it squeaked for over a year. This belt from Part Select was much better quality and now the dryer works perfectly, no squealing!

I simply put new knob on the little metal post where it belonged. Simple as pie.

i order the part on line came within 2 day push on knob that easy.

Slid new knob on shaft. Done.

As simple as pulling off the old, broken knob and sliding on the new one. 20 seconds tops.

Ordering on Partselect.com was easy, and shipped fast. This was my second order with Partselect.com, and I will order from then again, when whatever else can go wrong, goes wrong!