FGR211CAS1 Frigidaire Dryer - Instructions

Simply slid on the new knob. No tools necessary.

Popped the top... disconnected wiring... dropped the front... replaced coils... reversed sequence... done deal. No hassle, no worries, easy as 1-2-3!

Just a matter of taking off the broken knob and replacing it with the new one.

Removed the top of the dryer above the dryer door by pulling the pop out plastic holds. I then removed the dryer plug in at the top inside dryer that controls the start when dryer door is closed. I thenremoved the screws that are located at the back of the dryer tub where the bearing is located. I then replaced the support bearing. I just replaced every thing I took off in reverse.

I love technology. First thing I did was google on "U-tube", "How to repair a squeaking dryer". Several videos out there so I just found the one I needed and watched. The repair itself went easy. A word of advice would be to be careful of sharp edges and to remember to unplug the machine prior to repair. While the drum is out, go ahead and get your shop vac and clean the inside of the unit out. Also, not only put grease on the new plastic holder, but put some on the shaft of the idler puller. I also used an awl to line up the holes on the front panel when re-installing the screws. One video I watched showed reaching in through the front to take the drum belt off the pulley, where another showed removing the inspection plate on the back. This made it much easier.

Very easy fix on this system as described in other reviews. Simply unplug, lift top, remove two retaining screws on the dryer face, remove face from front of drum. Locate both coils at the lower left corner of the gas valve assembly.

Found part through Google, ordered part and received it in three days. Easy as pie

I tested continuity on parts like burner (ok) then on solenoids (not ok) timer (ok) I visited several websites and found the AppliancePartsPros.com site with FREE repair forum and found valuable advice. Then ordered my parts at Parts Select and were delivered 3 later at my front door.
Now a days you almost can forget to work on all the electronics in a wasmachine and dryer, unless you're a electronic guru.
THks.

I am very impressed with Part Select. My part arrived the next day without paying the extra shipping and my husband put the new knob on less than 30 secs.

Followed instructions and the repair went very smooth from start to finish. From getting tools out of tool tray to putting them back it took 15 minutes.

Just replaced old knob.
Service was great. Ordered knob on Sunday and received new one on Tuesday,

When the Time Knob broke, I planed to buy a new dryer. My friend told me of this site. I cheched the site and made the order, less than 36 hours, I received the part, less than 1 minute. I replace the knob and it bakc to work. It costs me only $15.

How I love this site!

I simply had to open the plastic and stick the new timer knob on the dryer. It fit perfectly and more importantly, it arrived within 48 hours of me placing my order. Thanks!

I replaced this belt once before but it squeaked for over a year. This belt from Part Select was much better quality and now the dryer works perfectly, no squealing!

Very easy to do, just take off old knob, and replace by pushing the new one on!