66213292K112 Whirlpool Dishwasher - Instructions

bought the adjuster kit and the hardest part was taking off the old pieces. the new pieces went on very easily and smoothly. I am a female that has done a lot of house projects and this was not difficult at all.

I read through the instructions which actually took longer than actually doing the repair because some of the pictures were a little dark and it wasn't clear exactly which direction the parts were facing. The repair went exactly as the directions said.

Watched on line video, helped tremendously. The video gave clear concise instructions.

Remove old rack adjusters. No removal instructions. Do one at a time. First requires some trial & error until removed. Install new replacement. Instructions not clear because pictures are dark & fuzzy. Again, install one with some trial & error. Second remove & replace becomes very easy.

I disassembled the left side, and installed the new assembly. However, being older and my eyesight not the best, and had assembled it slightly out of position. After adding more light, a magnifying glass. and a much closer look, I found my mistake. I reassembled the unit. The right side only took about ten minutes. I would recommend a larger more visible picture of the unit. I noticed that the units did not roll as easily as the old ones. One must give a slight push to engage the tray into the back of the dishwasher. Had the picture been better, it would have taken only 20 or 30 minutes to assemble.

I had left one adjuster on but the new ones were different. I started great but when doing the top part I didn't line up the wire rack with the holes in the upper adjuster plate and found out it was wrong so I had to use the pliers to unsnap the metal piece where they lock in. Once I got the first one complete it only took about 5 minutes to do the other side. The pictures included with the installation sheet were very dark. A you tube video would have been a great asset. It would have made it very simple and easy. In truth, the second side should only take a minute or two because I was only using one hand. My other arm was in a cast because I broke it. Anyone could do this.

Followed the enclosed instructions.

Removed all the old adjuster parts. Laid out new parts for each side. Would have helped if pictures had been better quality. Figured out how the parts would be installed before actually installing them. Almost messed up 2 plastic tabs by not understanding how 2 parts locked together with the tabs and shoved them together too far on the trial run but, was able to get them apart without breaking off the tabs. The new parts are a stronger design than the original. The tracks work like a dream. I rated it a "Bit Difficult" because in the pictures I could not see enough detail, otherwise I would rate it easy.

I went on line as instructed by one of your representatives and found clear instructions how to remove old part and put on new one. It was an excellent presentation. It can be found at w10712394 instructions

I looked up a you tube video of replacement for model and part. the video gave consise, clear and easy to follow directions. Using the video it took about 15-20 minutes to easily do the job.(I had difficulty seeing photos and reading printed directions that accompanied the part.)

Remove old parts , installed new

Trial and error

I watched this Youtube film: And it was really easy!

You tube feature on the replacement made it a very, very easy job.

While watching my infant daughter! The information strict ions and illustrations made my repair go easily. I removed the old parts and replaced the parts with ease.