5871434969 Kenmore Dishwasher - Instructions

Snapped new wheels into place on the axel. New wheels were exactly like the old ones

I pulled out the dishwasher removed the two heating element insulated wires and removed both threaded brass nuts and replaced them both. Problem solved. Luckily I have a local parts and repair store with a repairman that knows every part of every appliance ever made (no kidding, I have yet to stump him with a part or question). He did not have the parts, told me to go to partselect.com order two nuts, replace them both at the same time, and fix it myself because its an easy repair and not worth paying hundreds of dollars, if you can use a wrench. He was right, and partselect.com had the right parts, at the right price, easy to find and order, and I can impress the wife with my repair skills. Thanks again!

First I pulled out the old gasket, used this to measure for the new gasket, cut to right length, pushed new gasket into the track and washed a load of dishes. No leaks! This took about 2 minutes to complete.

Snapped the new one in. One second repair - like new.

Never worked on a dishwasher before but quickly learned that on this particular one, it's only this thin little brass nut that tightens down the element from the underside of the washer. If not tight enough, water drips right down onto the electrical connections. In this case water began to drip and the heat from the electrical current began melting a clear rubber shield thing. Luckily I was home during the cycle and figured out the problem. Great website that seems to have all necessary parts for my washer. Quick shipment!

Two rollers on the lower rack were missing and one was flattened. I popped off the bad roller and snapped the three new rollers in place, all by hand. Took about 60 seconds.

I snapped on the new roller and bingo! problem solved.

Removed kick plate at lower front of unit. At lower left is water inlet valve. Measured voltage across inlet valve solenoid at start of cycle. Was getting 120V to solenoid, but solenoid not opening valve thus no water going into dishwasher. Ordered replacement inlet valve. To remove inlet valve, disconnect two wires from valve assembly, disconnect water supply tube and remove two screws from mounting bracket. Now you can remove water hose that goes to dishwasher. Reverse order for install of new valve assy.

remove two small screws and slide the dishwasher out, lean it back and see where the water was leaking out. turn of the water remove water supply line and remove the water supply valve. then went to partselect.com and ordered new valve. the dishwasher is now like new for only $21.86 and UPS left the valve at my door in about 4 days::::LIFE IS GOOD

*Shut off power to dishwasher at circuit breaker (hot water supply had already been shut off under sink since inlet valve was broken and was allowing water to run into washer nonstop)

*Removed front lower panel from dishwasher

*Removed valve assembly from dishwasher frame

*Disconnected wiring harness from valve

*Disconnected incoming water line from valve

*Disconnected outgoing flexible water line from valve

*Installed new valve in reverse order

It was a pretty easy installation other than the small work area under the dishwasher.

Installed New rollers onto bottom rack. Part order & delivery were top notch from Partselect. Will definitely order from them again.

merely snapped the part on

Had a leak, due to the factory gasket was 1/2 " to short. Pulled out old one, installed new one, and trimed to fit. Took less the 5 minutes.

Fisrt, I opened dishwasher door. I then pulled out the lower rack & put new part in place and pushed in lower rack. Last, I closed dishwasher door.

removed old gasket by hand, installed new gasket with hands only. p.s. great doing business with you,thanks.