66513932K014 Kenmore Dishwasher - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from Willis, TX
- Parts Used:
- W10727426
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
the tine on the end rusted out and wouldn't stand up anymore
Pulled two clips off the rack and removed the tine row. Put the new tine row in, had to put both clips on at the same time. Very glad that the clips we had were not bad, because if they were, we would have had to order new clips too. They might consider including that with the tine row. Otherwise a fairly simple job.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from Lansing, MI
- Parts Used:
- WPW10352582
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Washer was non-functional
Determined that main control board was not providing power to control functions. Replaced board with new level of board that was a substitute for the original part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- DANIEL from DOVER, DE
- Parts Used:
- W10402110
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Wrench set
Dish washer would notstart. No elect power
First turn off power to the dishwasher at the circuit breaker! Check the door panel screws they were star screws which I was able to remove with an allen wrench(more difficult). Follow the instruction included in the Fuse package. Follow and understand each step before doing the task and it will go smoothly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- phil from santa rosa valey, CA
- Parts Used:
- W10619006
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
Kitchenaid Dishwasher Wouldn't Turn On
Replaced latch switch with parts-select whirlpool (usa) model (good choice) and unit still wouldn't turn on. I then turned 115 vac power off to unit for 1 minute and then back on and unit worked correctly with no additional problems. .
Was this instruction helpful to you?
Thank you for voting!