FDPC4314AS Electrolux Dishwasher - Instructions

Had a leak, due to the factory gasket was 1/2 " to short. Pulled out old one, installed new one, and trimed to fit. Took less the 5 minutes.

Orderd new gasket which arrived extremely fast, old gasket just pulls out , installed new one same direction as the old gasket fit, stopped leak. Thanks!

removed old gasket by hand, installed new gasket with hands only. p.s. great doing business with you,thanks.

Fisrt, I opened dishwasher door. I then pulled out the lower rack & put new part in place and pushed in lower rack. Last, I closed dishwasher door.

After removing the 4 torx head screws the cover and stem assembly was removed. The new piece was installed and screws were tightened. That is all it was to it. A very simple repair! Thanks.
D.W.Daniels

Remove the broken one. Install the new one.

Removed front panel and eased out screws holding the dishwasher in place. Lowered the door and removed old springs. Replaced the springs and sit the unit back in place. When they are this old it is best to replace both springs. Rated easy...,

The 'kick plate' had to be removed, and the feet had to be raised to lift the unit over the floor. the old spring could not be found, and while lying on the floor my husband had to 'feel' for the attatchments to hook up the new spring. The unit was then pushed back and the legs dropped and the unit attatched to the counter. All fixed - - thank you PartSelect for having the right spring.

My Son used needle nose pliers to remover the old gasket, then starting on the lower right side, inserted the new gasket and used the rounded end of handle of a wooden spoon and pressed the gaste in place by running the handle up and around the top then down the left side. Used sissors to cut the new gasket to length. Door fit very tight. Ran a normal wash cycle and no leaks.

Replaced spring on door

Rollers just snapped on the diswasher rack. Took just seconds to do.

just replace

All I have to say is paets select is the best company I have delt with in the last 20 years

I replaced the filter on the bottom of the dishwasher. The PartSelect website walked me through the whole thing. Thank you!!!

The hose goes from the water inlet solinoid to the side of the dishwasher.Remove the kick plate from the bottom front of the dishwasher. Disconnect the water supply to the inlet of the solinoid valve (copper tubing on mine). Remove the screws under the counter top which hold the dishwasher in place. slide the dishwasher out from under the cabinet only as far as needed to expose the hose(about 1 foot). The hose is behind the insulation. Remove the hose clamps from both ends of the hose(solinoid outlet and side of dishwasher)Remove hose carefully because this is all plastic. Install replacement hose and clamps. The new hose is several inches too short and will not fit into the upper hose guide, just bend it underneath. Be sure to put hose in lower keeper on side of dishwasher. Attach clamps, tape insulation back in place, slide dishwasher back under counter and install screws under counter. Attach copper tubing to water inlet solinoid valve. Run dishwasher and check for leaks. Replace kick plate. Note: I had enough loose electrical wire to slide my dishwasher out. If you don't have enough wire to slide out the dishwasher you should call a repair man.