DeWALT Laminate Trimmer Parts

Fix Number

FIX10189234

Manufacturer Part Number

N381728

This part is available as an individual replacement. The sub-base is made of plastic and attaches to the base. When replacing this part a screwdriver may be needed. It will require replacing if it becomes cracked or broken. This item is an original part from DeWALT for use in laminate trimmers.

Fix Number

FIX10189223

Manufacturer Part Number

N381709

Fix Number

FIX12508376

Manufacturer Part Number

N031636

This OEM part includes one carbon brush in metal housing. A worn or damaged brush will lead to motor issues and should ideally be replaced before this happens. It is a good idea to continue to inspect the brushes and replace as soon as they appear tarnished in any way. This is also an opportune time to inspect the armature for burns or cracks.

Fix Number

FIX10189194

Manufacturer Part Number

N381503

Fix Number

FIX10189218

Manufacturer Part Number

N381704

Fix Number

FIX10189193

Manufacturer Part Number

N381502

This is an authentic DeWALT replacement part, sourced directly from the manufacturer. The collet is found in a laminate trimmer, and is used to clamp the bit in place. This is a metal part, and is sold individually. To replace this part, you will need a wrench to loosen the collet nut, and then the collet should be simply to remove. You may also need a screwdriver to reach the part for replacement.

Fix Number

FIX12497015

Manufacturer Part Number

874538SV

This is a genuine OEM replacement part, it is sold individually. This Ball Bearing is sealed on both sides. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. • This reduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Fix Number

FIX10189212

Manufacturer Part Number

N381528

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with laminate trimmers. The base is a complete replacement part that is pre-assembled. This item is used to link the sub-base and the motor housing. This item is priced as a single item.

Fix Number

FIX10185751

Manufacturer Part Number

930802-00

Genuine DeWalt replacement part Includes 1 Carbon Brush with wire lead attached. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. • Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. • Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. • A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. • When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Fix Number

FIX10189229

Manufacturer Part Number

N381723