Briggs and Stratton Pressure Washer Parts

This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality part is made of durable metal and is sold individually.

This replacement hose is a genuine OEM sourced item that specially produced for use with Craftsman pressure washers. This 25 ft. high-pressure hose is made of durable rubber with metal fittings and it is sold individually. It can be used on pumps that produce up to 2600 PSI. Over time the material may deteriorate or get damaged eventually requiring replacement to maintain a working unit.

This is a filter cartridge for the air filter in various lawn equipment. The filter removes dirt, dust, and other debris from entering the carburetor, and contaminating the engine. If the engine in your machine is not operating properly, a dirty air filter could be the cause. This is a commonly replaced part, depending on usage we recommend checking it after a full season of use. You may clean this part once or twice using an air supply to keep it functioning properly. However, when it becomes dirty it must be changed.

This is a genuine Honda replacement part. Air cleaners are also known as air filters and are used to stop dirt, dust debris from clogging up and contaminating the carburetor and damaging the engine. When your air filter is dirty or clogged the engine may not start, or it might run rough. You can clean the filter a couple of times, but it should be replaced once is becomes clogged and dirty. This air filter uses two stage designs with paper pleats to ensure it is picking up the most dust, dirt and debris. Installing a new air filter is simple, you need to remove the air filter cover and the old air filter, insert the new filter and put the air filter cover back in place. This product is sold individually.

This fuel valve with bushing fits a variety of outdoor equipment and allows the fuel to smoothly flow into the gas engine. The bushing part is pressed into the hole provided in the fuel tank and the fuel valve is pressed through the bushing to reach the inside of the fuel tank. If your fuel valve is broken then it best to replace it. Refer to the manual provided by the manufacterer for more information on the part and installation instructions. Safety tip: remember to wear gloves and be cautious when removing fuel from the tank.