DeWALT Planer Jointer Power Cords

★★★★★

★★★★★

1 Review

Fix Number

FIX10169875

Manufacturer Part Number

330072-98

This power cord is used for power tools and some of the following tools: electric drills, reciprocating saws, jig saws, biscuit joiners, and routers. The power cord is made for double insulated tools and is a two-wire cord with two prongs, but it does not need a ground wire. If there are cuts in the cord insulation, intermittent power during operation, or damaged and bent prongs, then replacing the power cord will solve the problem. The tools needed for this repair are a Phillips screwdriver, small screwdriver, wire cutters/strippers, crimping tool, and terminal (ring or spade). Repair tip: During installation, remember that new cord wires must go correctly into wire terminals. Also, to avoid pinching when the tool case is put back into place, remember to route cord and wires in the right path.

Fix Number

FIX17061542

Manufacturer Part Number

N918736

This cord protector is a genuine DeWalt replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

Fix Number

FIX10169655

Manufacturer Part Number

330005-01

This is a cord protector, but it is also called a strain relief, and it is used with multiple power tools. This part is made of firm rubber to protect the cords from being pulled out or exposed, which would be a safety hazard. Over time the strain relief can develop cracks and break into pieces. This part is black and 4 inches long. The smallest end has a diameter of 0.5 inches. When completing this repair tuck in all wires to avoid pinching.

Fix Number

FIX10169874

Manufacturer Part Number

330072-97

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 18 Gauge • 10 Feet Long

Fix Number

FIX10176282

Manufacturer Part Number

5140011-91

Fix Number

FIX10177968

Manufacturer Part Number

5140089-85

Fix Number

FIX10184444

Manufacturer Part Number

770235

This replacement cord protector is an authentic component which is supplied by the original equipment manufacturer for use with DeWALT and Black and Decker power tools. It fits through the opening in the housing where the power cord is wired, it will protect the base of the cord from getting bent or pinched. It is made of high-quality rubber material and it is sold individually.

Fix Number

FIX10168745

Manufacturer Part Number

286041-00

Fix Number

FIX10184071

Manufacturer Part Number

663238-00

Fix Number

FIX12460548

Manufacturer Part Number

5140101-57