Makita Hammer Drill Caps and Lids

Fix Number

FIX10153918

Manufacturer Part Number

682502-4

This is a cord guard, also known as a strain reliever, for your power tools. Power tool cords go through a lot of stress during usage, and this part is designed to remove some of that stress from the weakest point, which is where the cord meets the tool. Depending on how often you use your power tool, your cord guard will deteriorate. When this happens, you should replace it immediately. Keeping a strong power cord guard will help your tool live a longer life.

Fix Number

FIX10153352

Manufacturer Part Number

643650-4

This is a brush holder cap for a variety of power tools. The cap contains the brush in the holder. It protects the motor brush on the motor brush holder by covering it. To remove the cap, you will need a slotted screwdriver. Do not press hard when removing this part, they break easily under pressure.

★★★★★

★★★★★

1 Review

Fix Number

FIX10153919

Manufacturer Part Number

682503-2

• This cord guard is a genuine Makita replacement part and is sold individually. • Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. • This cord guard will fit cords for the tools listed under the "Compatible Tools" listing. It is not guaranteed to fit any other cords.

Fix Number

FIX10151049

Manufacturer Part Number

421336-8

This dust cover is an original part from the Makita manufacturer. The plastic dust cover is made for use with the HK1810 Scraper. This feature fastens the tool retainer to the barrel cover. The dust cover is sold individually, and a wrench is required for the installation.

Fix Number

FIX10153385

Manufacturer Part Number

643829-7

This is an original Makita part. The holder cap is made of plastic and is used in saws and hammers. It attaches to the carbon brush and holds it in place. This cap is sold individually, however a screwdriver may be needed to replace this item if it becomes cracked or broken.

Fix Number

FIX10153940

Manufacturer Part Number

682572-3

This is an OEM part direct from the original manufacturer. The Makita cord guard 8 is made of durable rubber, and is compatible with various power tools. This item is often fastened into the housing and over the power cord, providing protection to the cord. The cord guard 8 is sold individually. A hex key and a screwdriver are helpful for the removal and repair. Please refer to the specific manual and diagrams for further safety and repair instructions.

Fix Number

FIX10153934

Manufacturer Part Number

682560-0

It is a genuine manufacturer-sourced which is specially designed for Makita power tools. Power cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point, right where the cord enters the tool. Unfortunately, over time the material will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality item is made of durable rubber and is sold individually.

Fix Number

FIX10151590

Manufacturer Part Number

450128-8

Fix Number

FIX11882548

Manufacturer Part Number

286288-8

It is an authentic Makita item that is supplied by the original manufacturer for rotary hammers. The cap prevents dust from falling over the tool and a user when performing overhead drilling operations. Attach the dust cup to the bit as shown in the figure. The size of bits which the dust cup can be attached to is as follows. Unfortunately, over time the material will wear out and it may begin to crack eventually requiring a replacement. Keep in mind this high-quality component is made of durable rubber and is sold as an individual item. Refer to the owner's manual for your model to ensure the correct repair procedure.

Fix Number

FIX10151138

Manufacturer Part Number

421596-2