OEM Snapper Leaf Blower / Vacuum Parts & Accessories

Ignition Coil

$25.11

Fix Number: FIX12637261
Manufacturer Part Number: 530035505

This is an authentic manufacturer made replacement part which is specially designed for use with Craftsman blowers. The ignition module produces the voltage that travels down the spark plug wire to the spark plug, then to the engine. This part is made of metal and plastic it is also sold individually. For installation you will need a screwdriver, a socket wrench and a pair of pliers to aid you. Before starting this repair be sure to let the engine cool completely.

Piston Ring

$6.25

★★★★★

1 Review

Fix Number: FIX16365561
Manufacturer Part Number: 545154001

This is an authentic OEM sourced replacement piston ring used on gas Trimmers and blowers. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase, causing low compression and a loss of power. If compression is reduced significantly, the engine will not run at all. This part is made out of metal and is sold individually. To complete this repair you will need a set of wrenches, pliers and a screwdriver.

Starter Handle

$6.25

Fix Number: FIX12617894
Manufacturer Part Number: 530054834

This handle is an authentic replacement part sourced and approved by the original equipment manufacturer. It is compatible with a variety of gas trimmers. This handle is attached to the end of the starter rope. By pulling the handle, the starter rope rotates the clutch assembly and starts the engine. This handle is made of plastic and sold individually.

Clamp-Right

$10.46

Fix Number: FIX16352943
Manufacturer Part Number: 530096026

Seal - C'Case

$7.46

Fix Number: FIX16352391
Manufacturer Part Number: 530019264

This is an original part from Craftsman for use with Leaf Blowers / Vacuums, Trimmers, and Hedge Trimmers. The seal crankcase prevents oil leaks between the crankshaft and crankcase opening. The most common reason for replacing the seal crankshaft is if there is leakage on the crankshaft, leakage from the crankcase, the oil seals are worn or damaged, the bearings are grinding or bearing seizures. This part is sold individually. Here is a list of tools that are needed to replace the seal crankcase is a receptacle for draining fuel, Torx wrenches, spark plug wrench or socket, a 10mm wrench (or adjustable), long-nosed pliers, rubber mallet, standard screwdriver, starter rope (or similar), adjustable pliers, socket set, 2-cycle engine oil (for lubricating seals), razor blade (to scrape gasket surface), and an ignition gapping gauge.

Plug spark (rcj6-y)

$6.25

Fix Number: FIX17084452
Manufacturer Part Number: 530030179

This is a genuine OEM sourced replacement part used with Poulan hedge trimmers. A spark plug delivers electric current from an ignition system to an internal combustion engine. After time spark plugs will become dirty or fouled. It is a good idea to replace the spark plug once this happens. This item is sold individually. You should gap your spark plug according to the owners manual of the outdoor product you have. You would need a spark plug wrench or a socket wrench to install this component.

Spark Plug

$5.84

Fix Number: FIX16404633
Manufacturer Part Number: 705647

RETAINING RING, EXT,

$6.25

Fix Number: FIX18603646
Manufacturer Part Number: 7012763SM

Kit-Throttle Lever (zama)

$5.97

Fix Number: FIX16352835
Manufacturer Part Number: 530071715

This is a genuine manufacturer-approved component which is designed for Poulan, Weed Eater and Jonsered backpack blowers. The throttle lever provides a user with a comfortable grip to adjust the throttle allowing to control the engine. It is an identical replacement for a missing or a faulty kit that was installed on a new unit. The kit contains one durable plastic throttle lever that works with Zama carburetors and one plastic retainer. Check the diagrams and the owners manual of your model for the exact location and the correct application of these parts.

$36.47

Fix Number: FIX12164064
Manufacturer Part Number: 530071775

The carburetor fits between the air box and the carburetor adaptor and is made of metal and plastic. It is an OEM from Poulan, Weed Eater, and Jonsered and is used in blowers. This part is available individually and may require a screwdriver during installation. It helps with the fuel mix and can be cleaned if it is causing problems with the engine, but will need to be replaced if it becomes broken.

Snapper Leaf Blower / Vacuum Parts

Popular Snapper Leaf Blower / Vacuum Parts

Snapper Leaf Blower / Vacuum Appliance Types

Related Snapper Leaf Blower / Vacuum Parts

Popular Snapper Leaf Blower / Vacuum Models

Snapper Leaf Blower / Vacuum Parts

Start With Your Model Number

Popular Snapper Leaf Blower / Vacuum Parts

Snapper Leaf Blower / Vacuum Appliance Types

Related Snapper Leaf Blower / Vacuum Parts

Popular Snapper Leaf Blower / Vacuum Models