Craftsman Hedge Trimmer Parts

Craftsman Appliance Parts

Popular Craftsman Hedge Trimmer Parts

SA SPOOL AND LINE DUAL
$18.56
In Stock
Fix Number
FIX18988542
Manufacturer Part Number
90567225N
This is a genuine Black and Decker replacement part,it is sold individually. This is the part of the String Trimmer that contains the cutting line. This part includes the spool and cutting line for the models shown below. This is a dual line spool. The cutting line is .065 gauge. It is replaced by removing the spool cover and placing it inside the spool housing, then feed some line through the spool housing and replace the spool cap.
Air Filter
$7.76
In Stock
Fix Number
FIX12633612
Manufacturer Part Number
530047932
This is an authentic replacement foam filter commonly used on handheld lawn and garden equipment. The purpose of this air filter is to prevent dust and other particles from entering carburetor and engine. Includes one (1) filter per order. Replacing this filter is a quick and easy task. It will only require a phillips head screwdriver. • Remove screw that hold filter cover • Remove cover and replace air filter • Reassemble and test your equipment
Flywheel
$39.59
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX16365732
Manufacturer Part Number
545221701
This is an original replacement part manufactured for use with handheld leaf blowers. The flywheel has magnets on its side that create an electric charge as the magnets pass the ignition module. The electric charge is sent to the spark plug to fire the air-fuel mix in the cylinder. The flywheel fits on the crankshaft by a key that aligns with a keyway on the crankshaft, this allows for proper firing timing. If the key on the flywheel is broken it can cause misfires or will not start at all. This flywheel is sold as an individual replacement part.
Piston Ring
$6.51
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX16365561
Manufacturer Part Number
545154001
This is an authentic OEM sourced replacement piston ring used on gas Trimmers and blowers. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase, causing low compression and a loss of power. If compression is reduced significantly, the engine will not run at all. This part is made out of metal and is sold individually. To complete this repair you will need a set of wrenches, pliers and a screwdriver.
Brush
$6.51
In Stock
Fix Number
FIX10170839
Manufacturer Part Number
387542-00
This replacement carbon brush is a genuine OEM authorized replacement designed for use with trimmers/edgers. This carbon brush is sold individually. Please note, brush holders and springs are sold separately. Carbon brushes are a commonly replaced part on power tools. Due to friction and normal use brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • First remove the screws holding the housing together • One you are able to access the motor you can remove old brushes • Install the new brushes • Re-assemble and test your tool
LEVER
$6.51
In Stock
Fix Number
FIX18988279
Manufacturer Part Number
90548553
This is a genuine Black and Decker replacement part, it is sold individually. The purpose of the 90548553 Lever, is to regulate the amount of line that is fed from the auto-feed spool. This part has a tendency to wear out often. It is advised to have an extra one on hand.
Rope Kit
$7.76
In Stock
Fix Number
FIX9008182
Manufacturer Part Number
530069232
This is a 3ft rope for a variety of power tools, most commonly chainsaws. It twists around the pulley of the recoil starter, which will allow you to pull-start the engine. This part is made of a durable nylon, but over time may wear out and snap. When that happens, you will need to replace it. Take note the plastic grip is sold separately.

Installation Instructions

David from BREMEN, IN
Recoil would not work properly and gas line was broken.
I replaced all of the worn out items with the new products I purchased from you. Thanks again, David Read more...
FUEL TUBE GROMMET
$2.99
In Stock
Fix Number
FIX18528471
Manufacturer Part Number
574678001
This is a genuine Poulan replacement part that has been sourced from the original manufacturer to be used with hedge trimmers. The fuel tube grommet attaches to the fuel tank. This item is used to seal the area around the fuel tube where the tube enters the tank. This item is sold as an individual replacement part.
Fuel Line
$15.54
In Stock
Fix Number
FIX9008192
Manufacturer Part Number
530069599
The fuel line carries the fuel from the fuel tank into the carburetor. This particular fuel line can be used in various lawn and garden equipment, such as trimmers and blowers. This clear rubber part can become weak and crack over time due to its constant contact with fuel, in which case will need to be replaced. It is sold separately and is an OEM quality replacement part.
Fixes these symptoms
Fuel Line Fitting
$7.76
In Stock
Fix Number
FIX9003834
Manufacturer Part Number
530023877
This is a genuine manufacturer-sourced item that is specially designed for use with Craftsman lawn and garden equipment. The purpose of this fitting is to connect two pieces of fuel line together, unfortunately, over time the material may wear out and begin to crack eventually requiring a replacement. Keep in mind this high-quality hardware is made of durable plastic and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item.
Fixes these symptoms

Installation Instructions

David from BREMEN, IN
Recoil would not work properly and gas line was broken.
I replaced all of the worn out items with the new products I purchased from you. Thanks again, David Read more...

Craftsman Hedge Trimmer Appliance Types

Popular Craftsman Hedge Trimmer Models