OEM Husqvarna Edger Parts & Accessories

Lawn Tractor Mandrel Assembly

$48.56

★★★★★

1 Review

Fix Number: FIX12087499
Manufacturer Part Number: 587819701

Installation Instructions

Terrence from LORENA, TX

Blade mandrel replacement

1. Remove mower deck.
2. Remove mower blade from defective mandrel.
3. Clean caked up grass from underside of mower deck.
4. Remove belt pulley from top of defective mandrel.
5. Remove four bolts fastening defective mandrel to deck. Note: bolts will most likely shear - make sure you have new ones.
6. Install new mandrel to deck using four new self-tapping bolts.
7. Reinstall mower blade to new mandrel assembly.
8. Reinstall belt pulley to new mandrel assembly.
9. Reinstall mower deck to tractor. Read more...

Bearing

$6.21

Fix Number: FIX9006914
Manufacturer Part Number: 532009040

This is a premium-quality OEM front wheel flange bearing (sometimes called bushing) commonly used in riding lawn mowers. They are used to keep the wheel held in place securely. It is sold individually but two are needed for each front wheel. It is recommended that they be replaced at the same time. Install this part with the flat side facing the grease zerk in the rear side of the wheel.

Watch the install video

Engine Fuel Filter

$4.99

Fix Number: FIX9285148
Manufacturer Part Number: 530095646

This fuel filter is for lawn and garden equipment engines. Fuel filter cleans the fuel before it reaches the carburetor. Work in a well-ventilated area when installing this part. Drain the fuel tank and disconnect the spark plug wire before beginning the repair.

Fixes these symptoms

Engine stops after a few seconds or minutes
Will Not Start
See more...

Installation Instructions

Aaron from BALTIC, OH

Wouldn’t start

Replaced fuel line and filter. Also replaced diaphragms, screens, float, needle and gaskets. It then started but wouldn’t keep running. I had to back out fuel air mix needle completely and spray carb cleaner in these holes. It then ran perfectly. Make sure you count the rounds they are backed off before removing. Read more...

Ring Klip Number T5304-75

$3.99

Fix Number: FIX9143890
Manufacturer Part Number: 812000029

This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.

Cap Axle Black 1 50 x 1 00

$3.99

Fix Number: FIX9007667
Manufacturer Part Number: 532104757

This is an OEM axle cap for lawn tractors and is sold individually. It stops debris from getting into the wheel hub and axle. This axle cap is prone to wear and tear and should be replaced when it is goes missing or appears damaged. No tools are necessary for this easy repair, simply locate the cap axle on the rim of the wheel and remove.

Washer 25/32 x 1-1/4 x 16 Ga.

$3.99

Fix Number: FIX9008998
Manufacturer Part Number: 532121749

This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.

Bolt and Washer Assembly

$8.71

Fix Number: FIX9020856
Manufacturer Part Number: 532193003

This manufacturer-approved bolt and washer assembly is for lawn tractors. Wear work gloves to protect your hands when installing this part.

Blade Mower

$16.18

★★★★★

1 Review

Fix Number: FIX9286056
Manufacturer Part Number: 532138971

This replacement blade is supplied directly from the original equipment manufacturer for use with Craftsman riding lawn mowers and garden tractors. It is secured under the deck to cut the grass, over time the blade may become dull or damaged causing irregular cutting patterns. Inspect your blades periodically and replace them as needed to maintain a clean cut lawn. It is a high-quality component which is made of durable steel and it is sold individually.

Nut, Hex, Flangelock

$4.99

Fix Number: FIX9022497
Manufacturer Part Number: 532409149

This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most models require three. For this repair you will need a wrench set.

Pulley Idler

$26.14

Fix Number: FIX9287043
Manufacturer Part Number: 532196106

This blade idler pulley (part number 196106) is for lawn tractors. Blade idler pulley 196106 applies tension to the blade belt, allowing the belt to turn.

Husqvarna Edger Parts

Popular Husqvarna Edger Parts

Installation Instructions

Installation Instructions

Appliance Type

Related Pages

Popular Husqvarna Edger Models

Husqvarna Edger Parts

Start With Your Model Number

Popular Husqvarna Edger Parts

Installation Instructions

Installation Instructions

Appliance Type

Related Pages

Popular Husqvarna Edger Models