Simplicity Chipper Shredder Parts

Shop By Appliance Type Shop By Part Type

Popular Simplicity Chipper Shredder Parts

Plug-Spark

$4.99

Fix Number: FIX9140427
Manufacturer Part Number: 796112S

This is a spark plug and it is found in various lawn equipment. If your engine is not starting or running poorly, you may need to replace the spark plug. This part is a RJ9LM. Meaning, it is a resistor type with a 14mm shell design, 3/8-inch reach, and 13/16-inch hex. The heat range is 9 for automotive, small engine, and ordnance applications. The LM indicates 14mm (special for lawn mowers). Before making this installation make sure to drain fuel from the tank and remove the old spark plug.

Fixes these symptoms

Will Not Start
See more...

Bearing, Ball

$8.83

Fix Number: FIX8887153
Manufacturer Part Number: 1705897SM

Starter Pawl-Ratchet

$3.99

Fix Number: FIX8942598
Manufacturer Part Number: 281505S

Sold individually.

Installation Instructions

James from Terry, MS

Won't shift

Won't shift checked shift bar was cracked used strong Philip screw driver in pin hole still won't move checked transmission was stuck oiled it then tap little with hammer till it slide refill the transmission case with thick oil grease. Stuck due to dust and wet climates little rust. Read more...

Fuel Filter

$3.99

Fix Number: FIX17016257
Manufacturer Part Number: 394358B

Fuel Filter

Filter- A/C Cartridge

$7.06

Fix Number: FIX8987387
Manufacturer Part Number: 491588S

This is a filter cartridge for the air filter in various lawn equipment. The filter removes dirt, dust, and other debris from entering the carburetor, and contaminating the engine. If the engine in your machine is not operating properly, a dirty air filter could be the cause. This is a commonly replaced part, depending on usage we recommend checking it after a full season of use. You may clean this part once or twice using an air supply to keep it functioning properly. However, when it becomes dirty it must be changed.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Gene from Meridian, MS

change the filter and foam

Loosen the black screw on side of mower and remove the filter and foam. Insert both the same way old ones were positioned, paper part of filter pointing away from the side of mower, and foam with sponge side against paper part on filter. (Screen side of foam facing out) Tighten the screw and you're finished. Read more...