Start With Your Model Number
Popular Auger Parts
Fuel Tank Vent
Fix Number FIX9183121
Manufacturer Part Number A356000031This check valve or the fuel tank vent is connected to the fuel tank in the following products: hedge trimmer, leaf blower/vacuum, chainsaw, edger, engine, tiler, auger, water pump, chipper shredder, sprayer, and brush cutter. The check valve allows air into the fuel tank to prevent vacuum when the fuel is being fed through the fuel line. Tip: if the vent is clogged, your engine may stall. Usually, the vent line is connected to a fuel grommet that is installed on the fuel tank. The tools needed for this installation are: needle-nose pliers and a small slotted screwdriver. Remember to wear work gloves to protect hands. Refer to the manual for an accurate repair guide.
Fix Number FIX11826309
Manufacturer Part Number A369000460This is an OEM fuel filter and is sold individually. This repair is very easy and will only take a few minutes. It is also a very important maintenance task that should be done regularly. This part is located inside the fuel tank and filters out debris to prevent it from making its way to the carburetor. If you notice fuel is leaking or their seems to be blockage, your fuel filter is likely in need of a replacement.
Fix Number FIX8858167
Manufacturer Part Number 12318140630This is a primer pump or primer bulb, and it is used on various outdoor lawn equipment. This part has an outer diameter of 0.616 inches, it is dome shaped, and transparent. The primer pump gives the engine of your machine a faster start by pulling fuel into the carburetor. If your pump is malfunctioning your machine will not receive the fuel it needs to operate properly. If you notice the primer pump is leaking you must replace it, as it could become dangerous.
Steve from Hilliard, OH
Replaced fuel line, primer,filter and hoesIn home shop Read more...
Fix Number FIX10053748
Manufacturer Part Number V490001230This is a clip for a variety of lawn and garden equipment. The clip is made of a durable metal, and is 6.5mm in diameter. This part is most commonly used to clamp tubes and hoses in place. The clip is sold individually.
Fix Number FIX9148697
Manufacturer Part Number 90050000005This nut is used for a variety of handheld gardening tools. The nut has multiple applications depending on the tool you are using. Refer to the diagram provided by the manufacturer for installation instructions and nut location in a specific tool. This lock nut is used to resist loosening when threaded onto a bolt. *Please note: this part is sold individually. The measurements are: 5mm.