Retaining Clip for Clutch

You have to line up the pin that engages the drive motor with the clutch. When the clip falls off the clutch drops and the tub wont move. Push the clutch up on the motor shaft and lock it into the pin on the motor shaft. Slip the curved portion of the clip through the groove in the motor shaft with the flat portion of the clip on the bott ... Read more om of the shaft. Push the curved portion through the groove and make sure that the lock tab on the flat part of the clip snaps over the end of the shaft. This clip can be difficult to get on as it is very stiff and that's where the screw driver comes in,,,,get the clip started and use the end of a flat blade screw driver to push on the back of the clip to push it all the way on until the lock notch on snaps over the end of the motor shaft, and your done

Remove the front panel and found the retaining clip for the clutch was broke and the belt was worn. Loose the four bolts from the motor, push the motor back and took off the belt out. install the retaining clip for the clutch put the belt and push the motor back to the front and tight the four bolts and that was all folks, easy. Thank you ... Read more for your service.