Washer Dryer Combo Hoses and Tubes

Rubber Injector Valve

★★★★★

★★★★★

1 Review

This part is commonly known to cause a leak at the top left corner of the outer tub. It fits over the injector nozzle.

Washer Hose with Bellows

★★★★★

★★★★★

1 Review

This washer hose with bellows, also known as a dispenser hose, is a genuine OEM replacement part for your washer. Replacing this part can be helpful if your washer is leaking. The dispenser hose connects the dispenser assembly to the tub. Before beginning the repair, unplug the washer and turn off the water supply. You will need a Phillips head screwdriver to complete this repair; a clamp tool can also be helpful. Remove the screws holding the lid of the washer in place, and take off the lid. Locate the dispenser hose and remove its clamps. Place the clamps on the new hose, using the arrows for a guide in positioning the clamps. Install the new hose and reassemble all other parts.

Tub-to-Pump Drain Hose

★★★★★

★★★★★

1 Review

This hose has bellows to allow for flexibility during the wash and spin cycles.

Washer Tub-to-Pump Hose The tub-to-pump hose carries the water from the tub to the drain pump. Unplug the washer and shut off the water supply before installing this part. Wear work gloves to protect your hands

Tub-to-Pump Hose Kit This kit comes with the clamps.

Plastic Injector Nozzle This injector nozzle is just under three inches long. It is white in color and made entirely of plastic.

HOSE ASSEMBLY,DRAIN

Outer Tub to Pump Hose

★★★★★

★★★★★

1 Review

This hose connects the outer tub to the pump of your washing machine. It is twelve inches long and all black in color. This hose is made entirely of rubber.

Inlet Hose - 5 FT This hose can handle hot or cold water and is five feet long.

Hose,Connector This part is the replacement connector hose or clean-out drain hose for your washer. It is black in color and is sold individually. The connector hose drains water out of the washer if the drain cycle is not working. If the hose breaks, it will not be able to drain the water properly, and you may experience a water leak. Be sure to disconnect your washer from the power source, as well as the water source before you begin this repair. This is an OEM part sourced directly from the manufacturer.