Plastic Injector Nozzle

Upon returning from vacation, we needed to do laundry-so I put some plastic under the washer and we did a load. The water was leaking from the seam between the lid and the back panel on the side with the hot and cold water connections- not the front. I removed two screws from the front bottom panel and two screws from the underside of the lid.Turning the washer on showed the leak was coming from the injection valve( it was brittle from age). The rubber injection valve was replaced and installed( using a little liquid soap to help the rubber hose to slip over the rubber injection valve) with a new clamp. The leak was fixed.

Viewed the You Tube video, which was excellent.

removed front panel via two screws near bottom, then lift top to expose water injecter hose. I pulled control knob to activate water fill to verify were it was leaking. Once replaced,I reactivated water fill to verify no leaks.

The U-Tube video from this site was great. SHOULD have taken a half-hour-- tops-- but the most difficult part was freeing up one of the screws at the bottom of the front panel. Finally had to drill it out. AFTER COMPLETING THE ACTUAL REPAIR, the leaking problem was solved.

I removed the front cover and disconnected the bleach filler tube from the top cover. I removed the two screws that held the top cover on and tilted the top cover back. I located the injector valve and determined that it was bad by starting the washer while watching the valve run over into the floor. I loosened the first clamp on the injector valve and slipped the injector valve and plastic nozzle out. I slid the new plastic injector nozzle into the new rubber injector valve. I rubbed a little grease around the rim of the injector valve so it would slide back into the hose easily into place. I reconnected the hose clamp and started the washer. No more water leak. I connected the bleach filler tube and put the covers back on. I put the washer back into it's place and started washing clothes. Its been two weeks and I haven't seen any water in the floor. This includes about six loads of clothes.

Looked it up on your site , watched the video, odered the part and put it on. Seems to have been the problem because it is not leaking now . Thank You for your prompt service