OEM KitchenAid Range Hood Parts & Accessories

Light Bulb - 40W

$8.87

Fix Number: FIX2376034
Manufacturer Part Number: 8206232A

To access the exterior lightbulb, the bottom panel of the microwave will need to be removed. It is secured in place with screws, so will require a Philips screwdriver to remove it. Screw the new light bulb directly into the light socket. If this is the first time you have replaced this light bulb, the old light bulb might be held in place with silicone. This silicone will need to be cut off using either a utility knife or dental floss before removing the light bulb. Once this silicone and old bulb has been removed, the replacement bulb can be screwed in its place.

Installation Instructions

Mark from North East, PA

Bulb burnt out

Removed the screw holding the bulb cover replaced the bulb. Reinstalled the cover and screw. Remove dirty grease filter replaced with new grease filter. Read more...

FILTER

$31.53

Fix Number: FIX11769929
Manufacturer Part Number: W10915369

Light Bulb

$36.80

Fix Number: FIX11752340
Manufacturer Part Number: WPW10298151

Grease Filter

$41.18

Fix Number: FIX2372036
Manufacturer Part Number: W10169961A

Sold individually. This metallic vent hood filter collects grease particles in the air from cooking.

Range Hood Light Bulb

$41.97

Fix Number: FIX11756469
Manufacturer Part Number: WPW10571723

Installation Instructions

Debbie from Jacksonville Beach, FL

replace grease filter of a hanging exhaust fan with a stainless steel cover around the pipe exiting through the roof.

The filter got lost during the renovation and I could not figure out the model or serial number and had trouble finding the information when I found the picture on line. After wasting an hour I gave in and called the phone number. Within a few minutes the operator figured out what I needed, got the part number, double-checked the info with me and I received it a couple days later. FANTASTIC SERVICE and WONDERFUL OPERATORS!! Thank you. Read more...

SWITCH-PB

$73.97

Fix Number: FIX12349685
Manufacturer Part Number: W11230930

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Edmond from Saint Martinville, LA

Switch to raise and lower the down draft vent system broke

Turn off breaker switch to the unit, Remove the cap by pulling straight up; unscrew the bracket secured by 2 small star screws. remove the old switch and insert the new switch. Replace the bracket and screw in. Put the cover into position and push in until locked. Turn the breaker on. Read more...