Admiral Dryer Elements and Burners

Admiral Appliance Parts

Popular Admiral Dryer Elements and Burners

★★★★★
★★★★★
10 Reviews
Fix Number
FIX334313
Manufacturer Part Number
279838
Sourced directly from the manufacturer, this heating element is an OEM approved replacement part for a variety of dryers and is sold individually. It measures approximately 10.5 inches long, 7.5 inches wide and 2 inches deep. The heating element is the primary source of heat used to dry the clothes in your dryer. This heating element is strung with a coiled wire made of a nickel and chrome alloy. It may need to be replaced if your dryer does not produce heat, if it produces too much heat, or if it will not turn on. If your dryer does not heat, first check for a blown thermal fuse on the blower housing before replacing the heating element. In most cases, the heating element will have a break in the element, making it defective. For this repair you will need a quarter inch nut driver and a pair of needle nose pliers. Start this repair by disconnecting the power and then remove the dryer vent. This repair is done from the back of the appliance with the back panel removed. With the panel removed, this will give you access to the heater element. Your next step is to remove the high-limit thermostat from the housing and remove the two wires from the heater terminals. Now remove the screws securing the element to the housing and slide the element out. Installation of the new part is done in the reverse order.
Fixes these symptoms
  • Heat stays on after drum has stopped
  • Noisy
  • Not Heating
  • See more...
★★★★★
★★★★★
4 Reviews
Fix Number
FIX11741416
Manufacturer Part Number
WP3387747
When connected to electricity the dryer heating element glows red hot and generates heat. When air is blown over it, it heats the air which is used to dry the clothes. The heating element fits inside the heater housing inside the dryer. Wear and tear on the heater coil from use will eventually cause the coil to break and the element to fail. When this part fails it can cease to produce any heat. Alternately, the coil could break and short to ground allowing the dryer to continue to heat even when turned off. The latter is a fire hazard and the dryer should be disconnected from power until the element is replaced. If the element coil breaks, the element needs to be replaced. This model is 11 by 5 inches with 5/16” terminals, metal and ceramic, and comes in black. It is sold individually.
Fixes these symptoms
Fix Number
FIX334206
Manufacturer Part Number
279457
This heating element connection wire kit is a genuine OEM replacement for your electric dryer. The kit is used to connect the thermostat to the heater element. The kit comes with a yellow wire nut and a wire that measures approximately 5 inches in length. If your dryer is getting little to no heat, or is taking too long to dry, you may need to replace this connection wire. Please be sure to disconnect the power supply to your dryer before replacing this part.
Fixes these symptoms
★★★★★
★★★★★
1 Review
Fix Number
FIX2162280
Manufacturer Part Number
LA-1044
Ensure your dryer performs at its best with this 4750-watt, 240-volt heating element kit. It’s responsible for producing the heat needed to dry laundry effectively. Common signs of a failing element include extended drying times or no heat during operation. To replace, unplug the dryer and use a putty knife, quarter-inch nut driver, and needle nose pliers. This part is sold individually and does not come with extra components.
Fixes these symptoms
Heating Element
$54.95
In Stock
Fix Number
FIX11757549
Manufacturer Part Number
WPY503978
This orange dot heating element replaces those elements with an orange dot on the element flange. It carries 240 volts.
Fixes these symptoms
Dryer Box Heater
$134.88
In Stock
Fix Number
FIX11746303
Manufacturer Part Number
WP8541818
The heating element is not included with this box.
Fixes these symptoms
Heater Box
$91.91
In Stock
Fix Number
FIX11703461
Manufacturer Part Number
W10802681
This dryer heater box is designed to securely house the heating element and support proper airflow for consistent, reliable drying performance. By protecting surrounding components from excessive heat, it helps prevent damage and reduce issues such as burning smells or visible warping. Built from durable metal, this replacement housing supports safe operation and helps restore efficient heat distribution within the dryer.
Heating Element with High Limit Thermostat
$227.90
In Stock
Fix Number
FIX2039492
Manufacturer Part Number
37001139
HEATER BOX ASM - ELEC.
$68.15
Special Order
Fix Number
FIX17216244
Manufacturer Part Number
W11676909
ELEMENT
$151.57
Special Order
Fix Number
FIX11770266
Manufacturer Part Number
W11026484

Related Admiral Dryer Parts