Dishwasher Valves

Water Inlet Valve - 120V 60Hz This is a genuine OEM replacement water inlet valve for your dishwasher. The water inlet valve supplies water to the dishwasher by opening and closing the solenoids attached to the valve, depending on the desired quantity of water. If your dishwasher is overfilling and leaking, or not filling with water at all, these may be signs that your valve is faulty. Other symptoms can include your dishes not cleaning properly, and the dishwasher not draining. You can check the inlet valve for continuity with a multimeter. It should show a reading between 500 - 1500 ohms if the valve is working and will read infinity if it is faulty. Another test is to open the dishwasher door while it is filling. If the tub continues to fill with water when the door is opened, the water inlet valve is defective and should be replaced.

Dishwasher INLET VALVE

★★★★★

★★★★★

1 Review

This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Water Inlet Valve This water inlet valve is for dishwashers. Water inlet valve supplies water to the dishwasher. Unplug the dishwasher and shut off the water supply before installing this part

Water Inlet Valve

★★★★★

★★★★★

2 Reviews

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Water Inlet Valve This water inlet valve is an authentic OEM part for your dishwasher. If can be found behind the lower kickplate panel in either the left or right corner. The valve has a solenoid that opens or closes in order to provide the required amount of water. If your dishwasher is leaking or will not fill with water, you may need to replace the water inlet valve.

Water Inlet Valve This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. NOTE: As per the manufacture this part has been updated from the original part. You may need to order an elbow (# W10685193) for the new designed valve to work.

Water Inlet Valve This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Drain Valve Shaft Seal

Piston and Nut Assembly This is used for the check valve.

Dishwasher Water Inlet Valve This part is the replacement inlet valve for your dishwasher. It is approximately 4-1/2 inches by 3-1/2 inches. The water inlet valve in your dishwasher connects to the water source and solenoid wires, and ensures the tub has the right amount of water entering it. If your dishwasher continues to fill after it is full, or if it fills slowly, you may need to replace this valve. Another indication that your valve is damaged and will need to be replaced, is if you notice it is leaking when the dishwasher fills up. Before you begin this repair, be sure to disconnect the water and power sources from your washer. This part is sold individually and is an authentic OEM part.