Magic Chef Dishwasher Pumps

Dishwasher Drain Pump If there is still water left in your dishwasher after it has finished running, there may be an issue with your drain pump. The pump is designed to remove water from the tub, and if that is not happening then it could be due to damaged that is causing the motor not to run or a crack causing a leak. If a new pump is required, this is a genuine OEM replacement part. Completing this repair will be easiest if you pull the dishwasher out from under the cabinet. You will need to disconnect both the water and electrical supply to the appliance before starting.

Dishwasher Chopper Assembly

★★★★★

★★★★★

1 Review

If your dishwasher is not cleaning your dishes properly, is not draining, or is noisy while operating, there may be an issue with your chopper assembly. The chopper is used to mince up food particles in the dishwasher, which prevents them from clogging up the pump. If you need to replace the chopper, this is a genuine OEM assembly for your dishwasher. Before beginning this repair, be sure to disconnect the power to your dishwasher. You will need to remove both the upper and lower racks from the dishwasher in order to easily access the chopper assembly. You will need a number 15 and number 20 torque screwdriver and a pair of needle nose pliers to complete this repair.

Accumulator and Filter This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

Impeller This is the replacement impeller kit for your dishwasher. This impeller kit comes with 4 pieces, including the impeller and seals which you will need for the repair. The impeller and seal kit is mounted on the dishwasher motor. If your dishwasher is not cleaning dishes properly, it may be an indication that your impeller has gone bad, and you are not getting proper water pressure. If the seals have gone bad, your dishwasher may start to leak. If you are having either of these problems, you may need to replace the impeller kit. Be sure to disconnect the water and power source from the dishwasher before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Wash Impeller This impeller rotates and is used to force water up through to the spray arm.

Impeller Assembly This impeller rotates and is used to force water up through to the spray arm.

Sump With Seal This part has a large port for the soil sensor and thermistor.

Pump Housing Kit This is the pump housing only.

Disk & Mount Assembly Used in the dishwasher pump area.

Wash Motor with Pump