Roper Cooktop Parts

Roper Appliance Parts
Shop By Appliance Type

Popular Roper Cooktop Parts

$5.60
  In Stock
Drip Bowl - 6 Inch
★★★★★
★★★★★
(4)
Fix Number FIX11750108
Manufacturer Part Number WPW10196406
This chrome drip bowl is an OEM approved replacement part designed for use with various models of electric ranges and cooktops. This drip bowl fits under 6-inch burner elements and has a diameter of approximately 8 inches. It sits under the burner, keeping any drips and spill contained. It is common for this part to become discolored, corroded, or otherwise damaged with time, and will need to be replaced. Each drip bowl is sold individually, so this is a good time to check the other drip bowls on the appliance in case you would like to replace those as well (sold separately). No tools are required for installation, simply line up the hole on the bowl with the terminal block and drop it into place. By routinely cleaning this part, it will help to prolong its life.
Fixes these symptoms
Installation Instructions
Henry from St Louis, MO
Replace old drip Bowls
Remove heating elements, remove old drip bowl, install new drip bowls replace heating elements. Read more...
$50.93
  In Stock
Heating Element
Fix Number FIX11742505
Manufacturer Part Number WP4391960
This element carries 5200W and 240V. Note: This element no longer includes two terminals and two adapter leads. They must be ordered separately.
Fixes these symptoms
  • No heat or not enough heat
  • Takes too long to dry
  • See more...
Installation Instructions
Steve from South Lake Tahoe, CA
Defective heater element dryer still runs.
Expect to spend a lot of time on your knees. Unplug appliance. Remove dryer hose. remove back cover 4-6 7mm bolts. Unplug dryer heater element connections 2 blade or pin connectors. Unbolt element cover and remove old element. Label wires. Hopefully the replacement connections match if not go to hardware store. Crimp or better solder on new connectors. Install element in housing and reattach. Clean out all old dirt and lint. check old belt for wear and re-grease drum roller shafts. re-install back cover, hose and plug in. enjoy you just saved $600 Read more...
$14.97
  In Stock
Drip Bowl - 8 Inch
★★★★★
★★★★★
(1)
Fix Number FIX2366563
Manufacturer Part Number W10196405RW
The drip bowl is found underneath the burner element of ranges with a rolled terminal style plug-in surface element. The purpose of the bowl is to catch any drips or spills that may occur while cooking. If the drip bowl has become damaged or tarnished beyond cleaning, it may be time for a replacement. This is a genuine OEM part that is 8-inches in size and is sold individually. When you replace the drip bowl, you will need to remove the element from the terminal block. At this time, you should also inspect the elements for any signs of damage or corrosion and replace them if necessary.
Fixes these symptoms
Installation Instructions
chris from ABERDEEN, SD
Burner would not heat up and the cook top on light would not turn off.
First turn off breaker. Pull out stove and unplug. There was about 8 screws on the panel on the back side of the control panel. Remove panel. Remove knob on the bad control and there is 2 screws behind knob. Remove those 2 screws and take the new control and remove 1 wire at a time from old switch to new one then put back together. Read more...
$13.39
  In Stock
Surface Burner Plug-In Block Kit
★★★★★
★★★★★
(4)
Fix Number FIX340571
Manufacturer Part Number 330031
This is a genuine OEM replacement part. This surface burner plug-in block kit is designed for use with surface elements of your ranges and cooktops. This kit helps connect the wire harness to the surface element. If your element is not heating, or if it only heats intermittently you may have an issue with your terminal block. This is a newer-style terminal block kit, it includes the plastic receptacle block, two metal brackets, two pre-crimped hi-temp wire leads with terminals, two ceramic nuts, two screws, and heat shrinking insulators. Before beginning this repair make sure you have unplugged your appliance.
Fixes these symptoms
Installation Instructions
Doris from Skoke, IL
Elements heat sporatically
I followed the steps in the instructions which were very easy, once the electric power was turned off to the range. I replaced 2 burner plug in blocks in less than 30 minutes. I am embarrassed to say that these burners have not been functional for almost 3 years. I thought that I could not work with electric. Just make sure you have the tools on hand and read the instructions first. I am a mid-50's female, if I can do this so can anyone else! Read more...
$5.69
  In Stock
Hex Nut
Fix Number FIX11738304
Manufacturer Part Number WP112432
10-32 hex - Sold Individually - Appliance originally takes 3 of this item.
$82.83
  In Stock
Broil Element
★★★★★
★★★★★
(1)
Fix Number FIX340509
Manufacturer Part Number 326795
This five loop broil element has a hanger style mount.
$42.77
  In Stock
Delta Frame Surface Unit - 6 Inch
Fix Number FIX11757480
Manufacturer Part Number WPY04100165
This 6 inch surface burner with reinforced delta frame carries 1250 watts and 240 volts. It has four turns and is compatible with many electric ranges. Its center medallion is all black in color.
Fixes these symptoms
Installation Instructions
Paula from Richmond, VA
the old elements were old and worn.
I simply pulled put the old elements and pushed in the new. It tool\k me all of about five minutes Read more...
$90.96
  In Stock
Burner Surface Element - 8 Inch
Fix Number FIX11740818
Manufacturer Part Number WP3177565
Sold individually.
Fixes these symptoms
$67.41
  In Stock
Igniter Switch
Fix Number FIX11742372
Manufacturer Part Number WP4330739
When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

Appliance Type

Popular Roper Cooktop Models