Have you ever purchased from us before?
Thank you for helping make our site better.
Manufacturer #: 330031 /
Manufactured by: Whirlpool /
Fix #: FIX340571
Manufacturer #: 330031 |
Manufactured by: Whirlpool |
Fix #: FIX340571
I followed the steps in the instructions which were very easy, once the electric power was turned off to the range. I replaced 2 burner plug in blocks in less than 30 minutes. I am embarrassed to say that these burners have not been functional for almost 3 years. I thought that I could not work with electric. Just make sure you have the tools on hand and read the instructions first. I am a mid-50's female, if I can do this so can anyone else!
Were these instructions helpful?
Per the instructions. I soldered my wires where I made the splice vs using the twist on wire connectors. Just feel better about them not coming apart.....other than that, it was easy peasy!
This is a drop in stove. Turned off power at breaker. Pulled the coils and drip pans to access screws holding the top on. Lifted top and unscrewed old block kit. Replaced block kit and secured it. Screwed down the top and installed new drip pans. Reinserted coils and reset power. All good.
Took back panel off just a few screws removed old switch replaced with new one replaced back. Lift stove top removed old block put new wire twist wire nut enclosed in package done works??
installation was simple just by following directions on package. Parts from this kit fit perfectly.
Turned off power at the curcuit breaker. Verified power off. Lifted cooktop out of countertop opening. Removed 10 screws holding the cooktop to the pan. Disconnected the wire at the infinite control switch. Remove small phillips screw holding the surface plug in block to the burner opening. Spliced the connectors to the new plug in block. Twisted the wires together and applied wire nut included in the kit. Placed shrink wrap sleeve over wire nut and heated with hair dryer to shrink the sleeve. Reversed the disassembly . Turn power back on and tested good.
Followed detailed instructions; removed "heating block" (one phillips screw), cut wires leading to "heat block" (took longer to strip 3/8" wire than to complete rest of project), connected wires in kit with provided wire nuts, assembled wires to "new heat block", installed with one phillips screw and done. Made me ashamed that it took 3 months to get around to doing a 20 minute project.
Cut wires to connector blocks, remove old plug block with Phillips screwdriver, assemble new block with correct bracket and screw bracket to stove top, strip ends of cut wires to same length as stripped wire of new block, slide shrink tube over wires, wire nut wires together. slide shrink tube over wire and heat with a lighter till shrunk over wire nut. Done.
Replaced both connections and wires from new Surface Burner Plug-In Block Kit. Took me a little while, have never done this before. Instructions were good, items perfect fit! Would order from again!
This was the second time I replaced the plug-in block. Turned off the circuit breaker. Took out the burner and pan. Opened the top of the range, disconnected the wire nuts. Unscrewed the block unit at the edge of the burner opening. The new block kit did not have the terminals assembled, so I looked to see how the old one looked and inserted the terminals into the back of the block until they snapped in. Put the heat-shrink sleeves on the terminal wires, then connected the wires from the range to the terminals with wire nuts. Pulled the sleeves over the wire nuts and heated with a lighter until they shrunk. Did not shrink as well as last time, but it looked to be good enough. Reattached the block onto the stove top, put in the pan and inserted the terminals from the burner into the block. Turned the electricity back on, and it works.
Building your dream green home doesn't have to be difficult. Lear…