GBVH5200J3WW General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Marianne from Bend, OR
- Parts Used:
- WH08X10036
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Door Boot Seal was ripped
Called a Repair Man, he came installed the part and I now have a working washer once again:)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Plainfield, NH
- Parts Used:
- WH23X10028
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
Washer pump faile
Removed old pump and replaced. Did not want to wait 2-3 weeks for a repair person
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ROBERT from EDGEWATER, MD
- Parts Used:
- WH08X10036, WH08X10021, WH01X10277, WH02X10206, WH01X10279
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers, Socket set
Torn Door Boot Seal
Remove the bottom panel. Remove the top. Remove the front panel with the door. Romove the two clamps on the boot seal. Remove the old boot seal. Place the new boot seal on the casing around the drum and ensure you put the gasket nozzle and gasket nozzle washer in place. Install the inside gasket clamp with the clamp bolt to the right as you look at it (Note: ensure the nut is over the tab on the boot gasket and stays lined up there as you tighten it. Replace the front panel of the washer and when it is in place put the boot seal on the outside lip (Note: this is the most difficult part as the gaskets does not like to stay in place as you put the outside clamp on. Replace the washer top. Replace the lower panel (Note: while you have the bottom panel off, you may want to clean the debrie trap which is a white pipe and tray that catches stuff that is left in pockets.) For the entire project I used 7mm and 8 mm sockets, flathead screw driver, and a philips head screw drive.
Was this instruction helpful to you?
Thank you for voting!