GCVH6600H1WW General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Donelly from Clovis, NM
- Parts Used:
- WH41X10119, WH41X10118
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Crack in Water inlet pipe.
Took of back and lower panel to check where leak was look up and notice the plastic piece cracked and then look up diagram of model and ordered part. Once it arrived it didn't take very long to repair. Easy to a bit difficult and no more leaks.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marianne from Bend, OR
- Parts Used:
- WH08X10036
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Door Boot Seal was ripped
Called a Repair Man, he came installed the part and I now have a working washer once again:)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- glenn from northfeild, NH
- Parts Used:
- WH41X10131
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
hole in drain line
All i did is pull the front panel off,then n removed the front clap with channel locks then the side clamp the same way.i then removed the main clamp with a Phillips screwdriver very simple not ever 15 minutes to do
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- J from cummington, MA
- Parts Used:
- WH08X10036
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
tear in door boot that leaked water
Best to watch youtube video and take the time to take washer apart and gain the access needed. I completed repair and dismantled the filter and cleaned it in about an hour, better than the average of 2 hours.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from Mount Kisco, NY
- Parts Used:
- WH41X10119, WH41X10118
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Water leak
Any repair should go easily if you have the right tools and the right PARTS. Like the before mentioned and all went well. The hardest thing about this particular water leak is identifining were the leak is. These parts are on the top of the washer. Take the top off and whamo there it is the cracked fill tube and smashed to hell washer. Real easy to replace. BUT that is really putting a band-aid on the problem. To me this washer was poorly designed by GE. Washer sits on a thick rubber mat, which sits on a conrcete floor and still jumps around, mainly when towels are in it.Fix that problem and then replacing these parts is a one time deal.
Was this instruction helpful to you?
Thank you for voting!