WBVH6240F0WW General Electric Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- J from cummington, MA
- Parts Used:
- WH08X10036
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
tear in door boot that leaked water
Best to watch youtube video and take the time to take washer apart and gain the access needed. I completed repair and dismantled the filter and cleaned it in about an hour, better than the average of 2 hours.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Madison, FL
- Parts Used:
- WH41X10118
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Water leak at front of washer
Removed top and front control panel. Shut off water, disconnect water lines at front and dispenser. Remove dispenser. Remove water inlet pipe by pulling out of boot. Install new pipe.Reverse proceedure. Note, these pipes may tend to split on the bottom.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LARRY from GREENWELL SPRINGS, LA
- Parts Used:
- WH41X10118
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers, Wrench set
Water dripping from soap dispenser outlet tube
Removed top cover, loosened front door cover, removed & replaced old cracked plastic 'water inlet tube', reinstalled front door unit & top cover. Very tight space to work in when not completely removing front door unit.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RON from APPLE VALLY, MN
- Parts Used:
- WH13X10023
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Hot water hose leaking, it was cross treated (twice) by the installer, would not warranty it the second time.
Followed your instruction, very easy. I installed Camco 90" & 45" Brass elbows to relieve strain on hoses.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jimmy from Zebulon, GA
- Parts Used:
- WH41X10118
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers
Water leaking from the door boot area.
I watched the video and followed the instructions. First remove power. Remove the rear cover from the control panel and the top cover. Then remove screws that secure the control panel to the frame and remove the control panel. Remove the bottom cover. Then remove the lock ring that holds the rubber boot to the front panel. Remove the door and remove the water inlet pipe. Assemble the machine and run a test cycle.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Luciano from Houston, TX
- Parts Used:
- WH41X10118
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
The Washer Was Leaking A Lot Of Water
I saw the video on how to remove the boot seal, and I just follow the instructions. Replacing the water inlet pipe was easy.
Was this instruction helpful to you?
Thank you for voting!