66513633100 Kenmore Trash Compactor - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Michael from Painted Post, NY
- Parts Used:
- 882699
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Broken Drive Gear
Removed the gear cover at the bottom of the compactor. Loosened the slack on the chain. Replaced the gear drive. Replaced the gear cover. Worked like new. No major obstacles.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from South Boston, MA
- Parts Used:
- 882699
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Compactor ram was stuck in the down position and door would not open
After inspecting to make sure the actuator was functional and that power to the unit was not an issue I was able to find that one the drive gears cracked in half and made the compactor inoperable. It was easy to remove the bottom casing with a nut driver. This casing covered the drive gear which operated the ram. After slightly loosening the gear mounts and I was able to replace center gear and re-attach gear chain and re-tighten. Then replace bottom casing and the compactor was back in action. Huge savings!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- E Arlene from Reno, NV
- Parts Used:
- WP9871920
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Part was missing
plugged it in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jane from Edmond, OK
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
switch broke off and would not activate compactor
removed two screws and replaced broken piece. Only thing a little difficult was getting screws in tightly enough to hold piece secure.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Douglas from Moorpark, CA
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
actuator broke at base. base remained in place.
Opened the compactor bin. Removed the failed actuator base (two screws) using hardened phillips # 2 screwdriver. prepped the new part holes by inserting the screws into (too small on replacement part) holes prior to installing(used needle nose pliers to hold part while prepping holes). Backed out screws from replacement part then installed part with same two screws using hardened phillips # 2 screwdriver. Tested functionality and received hug from son's grateful wife. P.S. I printed the parts diagram showing the part relationships from the website. Very helpful in repair planning. Recommend this to all. Do not know why the two rubber grommets were included in kit as they seem to apply to the horizontal screws securing the pedel itself that the actuator is installed on and are not needed for the repair.
Regards,
DougM
Regards,
DougM
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dan from Ramona, CA
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Could not activate the compactor
It simply required removing two screws that were holding in the remaining piece of the broken actuator, positioning the new actuator, and reinstalling the screws.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nancy from San Clemente, CA
- Parts Used:
- W10342596
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Broken metal depresser for button
First I removed the two screws that held the broken element in place. I replaced it with the new metal actuator. TA DA! Ordering was very easy even for me a girl! Shipment could have been faster though.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BYRON from OLIVE HILL, KY
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The switch actuator had broken and would not compact
I opened the door of the compactor and removed the old actuator with a scewdriver and replaced the new actuator.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Clovis, CA
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Part Shered Off At The Screws
Removed the screws holding the remaining piece and replaced it with the new part. Hardest part of this whole issue was making sure that I had the correct part on order. Would have liked to have been able to blow up the diagram for easier viewing.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Suzie from Northridge, CA
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The compactor was not compacting
The part has broken several times in several years. Each time it required a service call with a hefty fee. The fourth time I decided to do it myself. I ordered the part. It came faster than a service man would have and I installed it myself with a screwdriver in about three minutes. I will treat myself to lunch out with the girls with the money I saved!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Geoffrey from East Otis, MA
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Pressue bar on switch activator snapped off
Losses two screws, old part off; install two new screws, new part on. Piece of cake
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Julia from Huntingdon Valley, PA
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Trash compactor wouldn't compact when the food pedal was engaged
I removed 2 screws that held the brokent piece in place. I positioned the new piece and replaced the 2 screws. This is the 3rd time I've done this repair myself, it's so easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- MILIND from BEAVERTON, OR
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Trash compactor does not actuate
Very simple. 2 screws to unscrew - and then screwed the new actuator in. took less than 10 minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John R. from Cocoa, FL
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Switch activator broke
Replaced the broken part with a new part by attaching with 2 small sheet metal screws.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Francisco from Hernando Beach, FL
- Parts Used:
- W10342596
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Broken Part
Part replacement
Was this instruction helpful to you?
Thank you for voting!