RT0700C Makita Router - Parts

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing y...

This part includes two carbon brushes with wire leads and brush springs. Worn brushes are typically presented as a failed or underperforming motor. Carbon brushes are a part that commonly wears, so it...

This is a M4 X 10 countersunk screw, and it is sold individually. This screw is compatible with various models, so its location may differ depending on your equipment. To fasten and unfasten this scre...

This is a manufacturer approved replacement part designed for Makita grinders/sanders. This is the side handle 36 that provides a safe and stable grip for your tool. It is made out of plastic and meta...

This item is an authentic Makita replacement part that has been OEM sourced and is intended to be used with routers. The base protector attaches to the bottom of the trimmer base and is used to provid...

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or r...

This is a Rocker type switch that has internal terminals. This is a genuine Makita replacement part that is sold individually. rnrnSwitches are commonly replaced parts in tools. A switch handles on...

This item is a genuine Makita part that has been sourced from the original manufacturer to be used with trimmers, circular saws, sanders, routers, nailers, reciprocating saws, laminate trimmers, and p...

This brush cap is a genuine OEM sourced replacement part. It is commonly used on a variety of Makita power tools. This brush cap helps to secure the carbon brush in the brush holder. This cap has exte...

This part is available as an individual replacement part. The magnet sleeve goes between the stop ring and the wave washer. It is made of plastic and will require replacing if it becomes broken. A scr...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter...

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out ...