4ED20ZKIFW00 Whirlpool Refrigerator - Instructions

Just followed the video supplied with shipment. 5 minutes, even for a mechanically-challenged person.

Just as shown on your video.The refrigerator side was not sitting even, clunked and did not seal right. I decided to do.both sides, refrigerator and freezer while I was at it as our refrigerator is about 16 years old. Everything went in easily and saved us a lot of money. Very happy with the parts and repair video. Got the refrigerator nice and cleaned out while we were at it..Us and the refrigerator are breathing easier now..Yeepppeee....

I read a previous entry that stated the stud needed to be twisted out, which was very useful. I was bit worried at first when I removed the broken one and a bit of the insulation came out and it seemed mangled inside, but twisting the new one in worked. It is in there firm and strong, good as original.

I did some tests and determined that the tub-to-pump drain hose had a leak in it.I then looked on the web to find disassembly instructions. I have a stacked washer dryer combination in a very confined space. The repair involved disconnecting both the washer and dryer from the water, gas, electric and venting systems first, then unstacking the dryer from the washer (not so easy, it required a helper). The machine was then pulled out so I could get at the parts necessary to remove the outside components and sheet metal. Then, I disassembled the top, front and access panel in the back. The disassembly went very well. I got access to the drain hose assembly and removed it fairly easily. I ordered a replacement drain hose assembly and found that installing the large port of the assembly was very difficult. (The two other ports were easy.) After thinking about it, I tilted the machine back a bit so I could try it from the bottom. That worked fine.I then reassembled and tested the machine. No leaks. Good luck with yours!

remove top hinge take door off replace parts on bottm hinge put door back on done

To get the broken end cap off of the retainer bar, hold the retainer bar still and pull the broken end cap straight off on a line that is parallel with the retainer bar, and with a little tugging. Might even have to tap the end cap lightly. Slide the new cap back on to the retainer bar and then put the end cap back into the door slot by putting the bottom of the end cap into the slot first by tilting the upper part back a little, then pushing down on the end cap to get it down into the slot far enough to let the upper part go in. Then adjust the end cap up slightly to cause it to snap into place.

Simple fix. I watched the video it was great.

My husband twisted the stud off and was able to put the new ones in quickly

Removed right hand door of side by side. Replaced both cams and put door back. All is well.

i didn't repair replace capacitor, bi metal defrost thermostat and still not freeze also replace light door switch any suggestion thanks

very good

The refrigerator had to be pulled away from the wall far enough to permit the door to open fully, but no tools were needed and no difficulty was encountered. Removed the old drawer and discarded it. Inserted the new drawer and closed the humidifier vent. Pushed the refrigerator back in place. Job done.

I removed the screws holding the handle pieces to the refrigerator, then put the new handle in place and screwed in the screws.

inserted stud and twisted

Went online with the model number, the part was very easy to find, diagrams helped me to have confidence in the choice. Parts came in two days, tore them open and used a screw driver to replace the broken shelf brackets, replaced shelves, I am a happy camper!!