GI5SVAXVB03 Whirlpool Refrigerator - Instructions

Removed Phillips head screw on the front cover of both guides. Pull the drawer forward until it stops. Snap up the cover on each geared wheel to allow the basket to lift enough to continue removing the basket.
Swing the front of the guide rail towards the back which allows for the rear tab to come out of its hole.
Put new guide back in following reverse order.
Done!!

Removed the shelf below the cover to allow plenty of room to work spread apart the old cover at the pivot point toward the back installed the new one in reverse order

Removed the access panel on back of unit located the Run Capacitor on the compressor and removed the bad one and put the new one on and pugged refrigerator back in and it started up and works fine now

Remove damaged driver glides on both sides, save screws to reuse. Put right glider on right and left glider on left side of drawer and tighten screws with screwdriver.

Remove and replace

Popped out the old switch and replaced it with the one dying

Bought new cap.

Pushed on new one as directed online.

Used the suggested problem list here to narrow down that the repair was most likely the run capacitor. Poped the new one in and I now have better control of my compartment ranges. I have a temperature gauge in each compartment. Check them every opening of the doors.

Followed directions on filter unit

Quite simple, Remove the one bold and slide the rail-mulln off the retaining clips. They all face into the refigerator so it just slides off. Disconnect the sensing wire and reverse this three step process to install. Just be careful to have all three hindges aligned before you put the bolt in.

Unplug refrigerator. Lift and remove cup tray, exposing the two screws. Remove both. Gently pry the plastic bezel/cover from the door facing. Remove the three screws securing the black dispenser/circuit board assembly. Carefully disconnect the three cables from the circuit board (remember how they were routed). Being careful not to lose the spring clip, remove the defective actuator. Place the spring clip on the new actuator post and reattach actuator to the black housing making sure to hook the rear spring clip hook into the hole behind it. Using pliers, pull the front spring clip hook up so that it catches on the assembly post. While the dispenser assembly is off, good time to clean up any dirt, grime, etc from the assembly and door facing. Replace the assembly by reconnecting the three cables and using the three screws. Carefully snap bezel/cover in place and secure with the two screws. Replace cup tray.

Can not do repair. Ordered part 3/30 due to me on 4/1. Today is 4/15 and still no part. I even paid for quicker delivery. Thanks FedEx!!

Removed 4 bottom screws. Removed module screws. Replaced module and motor with new parts (came assembled). Replaced module screws and installed the ice maker with the 4 bottom screws.

1) Turn off the power to the refrigerator 2) Remove the top shelf and ice maker door 3)Remove three hex screws holding the ice maker in place, 4) Unplug the electrical cables and remove the ice maker 5) Remove the plastic cover to the motor module 6) Remove three screws from the motor module and seperate from the housing 7) Remove two mounting screws for the motor module 8) Seperate the motor module from the ice tray 9) Remove and replace the plastic ice stripper and rake10) Reassemble in reverse order. Note: Be patient after re-installing the ice maker. It might take an hour or two before its cold enough to kick back on and make ice.