WRX735SDBM Whirlpool Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- JOE from BATON ROUGE, LA
- Parts Used:
- W10679370
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
Wrong Part Sent (interior light)
I received the wrong part - had to pay returnin shipped and restock fee. Lost out on dealing with this company. Went to Whirlpool site and got correct light for my refrigerator
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daniel F from CALEDONIA, MN
- Parts Used:
- W11613295
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Freezer and refridgerator just stopped working.
The Condenser Fan Motor was already removed due to searching for the problem. The new fan motor looked different from the original but I felt very comfortable that Part Select had sent me the new part showing original part number changing numbers over the years. Simply placed the fan blades onto the new motor lined up 2 of the holes placed screws and tightened then plugged the wire ribbon into the Condensor Fan Motor, plugged in the Refridgerator and it worked beautifully.
The instruction video on the Part Select Web Site made it so incredibly easy to install. Installation took under 3 minutes!
The instruction video on the Part Select Web Site made it so incredibly easy to install. Installation took under 3 minutes!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- C D from CATHEDRAL CTY, CA
- Parts Used:
- WPW10196393
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Refrigerator section too cold, temperature usually @ 30 degrees, freezer ok
First off, I learned from YTube how to go about figuring out what might be wrong & how to fix it. I watched numerous videos and narrowed it down to the damper as the part to be replaced. I learned how to use the Jazz Board in the fridge to test components & verified the damper wasn't getting signal to open/close. I removed the old damper & put in the new one following what I had seen on the videos. I found a video that had the same type of damper assembly as my fridge & used it to show me how to remove & replace the damper. This was the 2nd part I had to replace to get my fridge up & working. I spent a total of 224.00 on parts and now the fridge is quieter than it's been in years. Finally, if a 66 year old woman can do this, so can you. Just watch YTube & also PartsSelect also has videos also.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Zinkin from MOUNT DORA, FL
- Parts Used:
- WP67006331
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Old water filter cover would not stay up.
Watched a couple of videos. Removed left side hinge first, then did the same to the right side hinge. Part was installed in reverse order. Installation took less than 60 seconds.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph from Phoenix, AZ
- Parts Used:
- WPW10300024
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Ice jammed on exit from ice maker
Removed old ice maker. Unscrewed unit from slide. Unplugged old wire. Screwed on new unit. Replugged in wire. Slid ice maker back into refrigerator and all worked properly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ALICE from SPRING HILL, FL
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
filter needed to be changed
followthe instructions in the book that came with the refrigerator
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Roger from SMITHFIELD, RI
- Parts Used:
- W11613295
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
The referigerator is warm, but the freezer is cold.
I noticed the coils very dusty dirty, tried brushing it clean, ended up blowing it clean. I noticed the condenser fan motor was never turning, I had power, so I ordered a new one. I actual received the evaporator motor, so I had to order the correct one. After changing it, and it started blowing right away. But my refrigerator is still warm. I do not know where the evaporator blower motor is located. I cannot make out from the diagram breakdown. HELP
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Arlene from MANDAN, ND
- Parts Used:
- W10882923
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers, Socket set
Fridge was barely 3 years old and the ice maker started having issues
Removed the old ice maker, which was a bit difficult, replaced the new one, which was also difficult, as the wire harness was not the same.If it would have been the same, replacing the ice maker would have been no problem at all!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Earl from Hollister, CA
- Parts Used:
- W11043011
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
LED Light out
A Screw took off cover unpludge LED lite
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from ST SIMONS IS, GA
- Parts Used:
- W11043011
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
LED refrigerator light began flickering (the dreaded strobe effect)
I actually followed the directions provided by individuals who posted to YouTube. This is my normal go-to for jobs I think I can do myself. Since the module is a plug-in, the important info provided by the video was how to remove the cover and module without causing damage.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Myrna from Port Carbon, PA
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
ice maker not working
replaced ice and water filter
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Elizabeth from Greencastle, IN
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
It was time to change the filter for the first time
Opened up the door that covered the filter, unscrewed it and put the new one in and closed the door back up.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donald from Woodstock, GA
- Parts Used:
- WPW10498990
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver
Icemaker stopped making ice
Old valve is working, and I can't find out whats wrong. Looks like I will have to replace the icemaker.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- D J from BOAZ, AL
- Parts Used:
- WPW10498990
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Wrench set
Replace variable speed pulley assembly
The housing bracket assembly didn't come close to fitting my lawnmower. I took the pulley and bearings out of the replacement one and put them in my old housing. This got me back to mowing, but it took quite awhile to make the switch.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Newaygo, MI
- Parts Used:
- EDR4RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
no problem
took old one out installed new turn left out turn right in
Was this instruction helpful to you?
Thank you for voting!