WRFF5333PB00 Whirlpool Refrigerator - Instructions

Checked Video online. Had to remove the 2 snap on track/gear covers. Pry out the gear with screwdriver and the gear bearing unit. Align the flat side of the bearing unit and snap in. Position the cut teeth on the gear to match original and snap into the bearing. Insert the connecting rod into the long shaft gear and then push back into the short shaft gear. The video said to remove the drawer front but I did not and don't see that it necessary.

Laid out new gaskets in sunlight to make them pliable. Removed old gasket by gently pulling them out of the channels around the door. I then did the reverse with the new gaskets. Starting at the top I pushed the new gasket into the channel, moving in one direction around the door. Make sure the outer lip of the gasket does not fold under itself. It should lie flat on the surface of the door. It is truly that easy.

Shut off water supply. filter is located in the upper right hand corner of the refrigerator on the inside. open the drop-down door. by hand pull the filter downward. then twist it to the left one quarter turn. it should pull out. I replaced it with a filter bypass plug. you can purchase a high quality filter to replace.it don't buy cheap filter.I made that mistake! hope this helps good luck!

Took out 2nd new filter $43.00 each that clogged in less than 2 weeks each and installed in 2 mins. this bypass and ice and waterr work perfect.Thank you, thank you for your exceptional service ordered part and it came next day without extra charge,great service.

We had an Appliance Repair service come to fix, and they replaced the ice maker and the water valve, but ice maker was still not performing properly. We use RO water to fill the ice maker and because the water was also going through the charcoal cartridge, there wasn't enough water pressure to completely fill the tray. Plus charcoal filter was probably clogged. The original Blue Bypass Cap was nowhere to be found and I even called Kitchenaid to get one. They were of no help. But found your site, and found the part I needed. And best of all, ice maker is not jamming and is now making real ice cubes, not hollow, thin ones. And the water dispenser is now working too, so am very happy that such a small thing, fixed the big problem. Who knows, a clogged charcoal filter may have been the whole problem from the start.

Replaced the water filter with the bypass plug. The water in western NC is perfect out of the faucet.

TAKE NOTE HOW OLD GASKET IS ORIENTED!!!old gasket can be removed by starting to pull out at top left hand corner, there is just enough space behind hinged door flap to put a finger behind the gasket and moving down and behind the flap remove gasket from it's slot, once you reach the bottom of the door the rest of the gasket is very easily removed. If new gasket is deformed in shipping, use a hair dryer to help staighten. Loop new gasket over shelf inside door. start at top left corner and continue inserting gasket into it's slot all the way round.

Simply remove the filter and insert the bypass cap in its place. Cap turned a little hard but if your careful everything goes together easily.

very basic (I repaired appliances for 10 yrs for Sears and my own shop)make sure you apply heat(hair dryer) to have seal in perfect square shape soft etc ,I removed freezer door put plastic tarp to keep cold in, laid door on table for ease of installation replaced gasket put door back on tout fini ps if you want lay on floor go for it at 75 yrs old not for me Newport VT

Looked at the appliance's booklet to see how it fit together, then installed it.