59678339803 Kenmore Refrigerator - Instructions

Popped out the old switch and replaced it with the one dying

Bought new cap.

Just plugged it in

Watched a couple of videos. Removed left side hinge first, then did the same to the right side hinge. Part was installed in reverse order. Installation took less than 60 seconds.

remove two crispers and glass top . Replace rail.
Note
This is 3rd time this part in about 5 years has needed replcement. If there is a next time I would expect a "freebe". Service is great and replacement rail came in jig time.

Repair was tremendously easy. All I did was remove old light switch by prying out with screw driver and plugging in the new light switch and pushing it into the hole. Simple! The instructions weren't needed, but they were very thorough.

Had to push the light switch to get lamp to light up.
Removed power from refrig. and removed old light switch
and replaced with the one I got from Partselect. Turned power back on and was done.

In less than 1 minute I put the crisper glass in place. I wa overwhelmed at the speed in which I received this part. It was ordered on monday evening and I received it on wednesday morning. PartSelect was a life saver as the repair was just day before Christmas.

The repair was very simple, just put the parts in place. We were very please with the quick shipment and the good prices.

1) Turn off the power to the refrigerator 2) Remove the top shelf and ice maker door 3)Remove three hex screws holding the ice maker in place, 4) Unplug the electrical cables and remove the ice maker 5) Remove the plastic cover to the motor module 6) Remove three screws from the motor module and seperate from the housing 7) Remove two mounting screws for the motor module 8) Seperate the motor module from the ice tray 9) Remove and replace the plastic ice stripper and rake10) Reassemble in reverse order. Note: Be patient after re-installing the ice maker. It might take an hour or two before its cold enough to kick back on and make ice.

Removed 4 bottom screws. Removed module screws. Replaced module and motor with new parts (came assembled). Replaced module screws and installed the ice maker with the 4 bottom screws.

Unplug refrigerator. Lift and remove cup tray, exposing the two screws. Remove both. Gently pry the plastic bezel/cover from the door facing. Remove the three screws securing the black dispenser/circuit board assembly. Carefully disconnect the three cables from the circuit board (remember how they were routed). Being careful not to lose the spring clip, remove the defective actuator. Place the spring clip on the new actuator post and reattach actuator to the black housing making sure to hook the rear spring clip hook into the hole behind it. Using pliers, pull the front spring clip hook up so that it catches on the assembly post. While the dispenser assembly is off, good time to clean up any dirt, grime, etc from the assembly and door facing. Replace the assembly by reconnecting the three cables and using the three screws. Carefully snap bezel/cover in place and secure with the two screws. Replace cup tray.

I noticed the coils very dusty dirty, tried brushing it clean, ended up blowing it clean. I noticed the condenser fan motor was never turning, I had power, so I ordered a new one. I actual received the evaporator motor, so I had to order the correct one. After changing it, and it started blowing right away. But my refrigerator is still warm. I do not know where the evaporator blower motor is located. I cannot make out from the diagram breakdown. HELP

Pried out the old switch and installed the new switch.

removed drsws and shelf put new center rail replaced draws done